PE9701 Datasheet, PDF (4/13 Pages) Peregrine Semiconductor Corp. – 3000 MHz UltraCMOS™ Integer-N PLL Rad Hard for Space Applications

PE9701
Product Specification
Table 1. Pin Descriptions (continued)
Pin No. Pin Name Interface Mode Type
31
VDD-fp
ALL
(Note 1)
32
Dout
Serial, Parallel
Output
33
VDD
ALL
(Note 1)
34
Cext
ALL
Output
35
VDD
ALL
36
CP
ALL
37
NC
ALL
(Note 1)
Output
Description
VDD for fp
Data Out. The MSEL signal and the raw prescaler output are available on Dout
through enhancement register programming.
Same as pin 1.
Logical “OR” of PD_U and PD_D terminated through an on chip, 2 kΩ series resistor.
Connecting Cext to an external capacitor will low pass filter the input to the inverting
amplifier used for driving LD.
Same as pin 1.
Charge pump current is sourced for “up” when fc leads fp and sinked for “down”
when fc lags fp.
No connection.
38
VDD-fc
ALL
39
fc
ALL
40
GND
ALL
(Note 1)
Output
VDD for fc
Monitor pin for reference divider output. Switching activity can be disabled through
enhancement register programming or by floating or grounding VDD pin 38.
Ground.
41
GND
ALL
Ground.
42
fr
ALL
Input
Reference frequency input.
43
LD
44
Enh
ALL
Serial, Parallel
Output,
OD
Input
Lock detect and open drain logical inversion of Cext. When the loop is in lock, LD is
high impedance, otherwise LD is a logic low (“0”).
Enhancement mode. When asserted low (“0”), enhancement register bits are
functional.
Note 1: VDD pins 1, 11, 12, 23, 31, 33, 35, and 38 are connected by diodes and must be supplied with the same positive voltage level.
VDD pins 31 and 38 are used to enable test modes and should be left floating.
Note 2: All digital input pins have 70 kΩ pull-down resistors to ground.
©2003-2006 Peregrine Semiconductor Corp. All rights reserved.
Page 4 of 13
Document No. 70-0035-02 │ UltraCMOS™ RFIC Solutions