ZY7010L Datasheet, PDF (14/34 Pages) Power-One – 10A DC-DC Intelligent POL 3V to 13.2V Input 0.5V to 5.5V Output

ZY7010L 10A DC-DC Intelligent POL Data Sheet
3V to 13.2V Input • 0.5V to 5.5V Output
6. Typical Application
SD
I²C
DPM OK_C
OK_B
OK_A
Intermediate Voltage Bus
CS
ZY7010
ZY7010
ZY7010
ZY7010
ADDR
ADDR
ADDR
ADDR
V1
V2
V3
Figure 25. Block Diagram of Typical Multiple Output Application with Digital Power Manager and I²C Interface
The block diagram of a typical application of ZY7010L point-of-load converters (POL) is shown in Figure 25. The
system includes multiple POLs and a ZM7000 series Digital Power Manager (DPM). All POLs are connected to
the DPM and to each other via a single-wire SD (sync/data) line. The line provides synchronization of all POLs to
the master clock generated by the DPM and simultaneously performs bidirectional data transfer between POLs
and the DPM. Each POL has a unique 5-bit address programmed by grounding respective address pins. To
enable the current share, CS pins of POLs connected in parallel are linked together.
There are three groups of POLs in the application, groups A, B, and group C. A group is defined as a number of
POLs interconnected via OK pins. Grouping of POLs enables users to program, control, and monitor multiple
POLs simultaneously and execute advanced fault management schemes.
The complete schematic of the application is shown in Figure 26.
ZD-00422 REV. 2.2
www.power-one.com
Page 14 of 34