NPIC6C595_15 Datasheet, PDF (7/20 Pages) NXP Semiconductors – Power logic 8-bit shift register; open-drain outputs

NXP Semiconductors
NPIC6C595
Power logic 8-bit shift register; open-drain outputs
Table 5. Static characteristics …continued
At recommended operating conditions. Voltages are referenced to GND (ground = 0 V).
Symbol Parameter
Conditions
V_CC = 5.0 V; T_amb = 25 C
Min
Typ
Max
V_OL
LOW-level output serial data output Q7S; V_I = V_IH or V_IL
voltage
I_O = 20 A; V_CC = 4.5 V
I_O = 4 mA; V_CC = 4.5 V
I_IH
HIGH-level input V_CC = 5.5 V; V_I = V_CC
current
-
0.005
0.1
-
0.3
0.5
-
-
1
I_IL
LOW-level input V_CC = 5.5 V; V_I = 0 V
current
-
-
1
V_(BR)DSS drain-source
breakdown
voltage
I_D = 1 mA
33
37
-
V_SD
source-drain
diode forward voltage; I_F = 100 mA
voltage
-
0.85
1.2
I_CC
supply current logic supply current; V_CC = 5.5 V;
V_I = V_CC or GND
all outputs off
-
0.004
200
all outputs on
-
0.006
500
all outputs off; SHCP = 5 MHz; C_L = 30 pF;
see Figure 14 and Figure 16
-
0.75
5
I_O(nom) nominal output
current
V_DS = 0.5 V; T_amb = 85 C; I_out = I_D
[1][2][3]
-
140
-
I_DSX
drain cut-off
V_CC = 5.5 V; V_DS = 30 V
-
current
V_CC = 5.5 V; V_DS = 30 V; T_amb = 125 C
-
R_DSon
drain-source
on-state
resistance
see Figure 17 and Figure 18
V_CC = 4.5 V; I_D = 50 mA
V_CC = 4.5 V; I_D = 50 mA; T_amb = 125 C
[1][2]
-
V_CC = 4.5 V; I_D = 100 mA
-
0.002
0.2
0.15
0.3
3.0
9
5.4
12
3.1
10
Unit
V
V
A
A
V
V
A
A
mA
mA
A
A



[1] This technique should limit T_j  T_amb to 10 C maximum.
[2] These parameters are measured with voltage-sensing contacts separate from the current-carrying contacts.
[3] Nominal output current is defined for a consistent comparison between devices from different sources. It is the current that produces a
voltage drop of 0.5 V at T_amb = 85 C.
NPIC6C595
Product data sheet
All information provided in this document is subject to legal disclaimers.
Rev. 1 — 20 August 2012
© NXP B.V. 2012. All rights reserved.
7 of 20