ERA-3YEB361V Datasheet, PDF (4/10 Pages) Panasonic Semiconductor – PRODUCT SPECIFICATION FOR APPROVAL

Subject
Metal Film(Thin Film) Chip Resistors PRODUCT SPECIFICATION FOR INFORMATION
Part No.
ERA3
Spec. No.
151-SRA-E102R
10－3
5. Appearance & Construction
Item
Rated value
Explanation
1. The resistive element should be covered with protective coating
that don’t fade easily. The surface of coating should avoid
unevenness, flaw, pinhole and discoloration.
Appearance & 2. The electrode should be printed uniformly, as shown in the
Construction
dimensions. The plating should not fade easily, and should avoid
unevenness, flaw, pinhole, projection and discoloration.
3. The electrode should be connected electrically, mechanically to
resistive element.
As far as there shall not designation especially, the following test and measurement
shall be operated under normal temperature (15~35°C), normal humidity(25~75%),
normal atmospheric pressure( 8.6 ×10⁴ ~1.06 ×10⁵ Pa ).
6. Performance Specification
Item
Specifications
Chip Resistor
DC
Resistance
DC Resistance value shall
be within the specified
tolerance
Temperature
Coefficient
Resit. range TCR
10Ω
~97.6Ω
± 50x10^-6/°C
100Ω
~33 kΩ
±25x10 ^-6/°C
33.2kΩ
~330kΩ
±100x10^-6/°C
Short-time
overload
± (0.5 % + 0.1Ω)
Dielectric
Withstanding
No evidence of flashover,
mechanical damage,
arcing or insulation break-
down
Explanation
At 20°C, 65%RH
Natural resistance change per
Temperature degree centigrade.
R 2 − R1 _×106
R1(t 2 − t1)
(10^-6/℃)
R1 : Resistance value at reference
temperature(t1)
R2 : Resistance value at test
temperature(t2)
t2 – t1 = 100°C t1 = 25°C
Resistors shall be applied 2.5 times the
rated voltage for 5 seconds.
However, the upper limit of the voltage in the
test shall be 150V.
AC 100V between substrate and termination for
1 min.
AC
powersupply
or
Insulation
resistance
Insulation
Resistance
Min.1,000MΩ
Resistors shall be facing down. After applying DC
100V to the resistor, insulation resistance shall be
measured.
Panasonic Electronic Devices Co., Ltd.