English
Language : 

OXCF950 Datasheet, PDF (26/66 Pages) Oxford Semiconductor – Single full-duplex asynchronous channel 128-byte deep transmitter / receiver FIFO
OXFORD SEMICONDUCTOR LTD.
OXCF950 rev B DATA SHEET V 1.0
0x15
CISTPL_VERS_1
0x15
0x07
0x01
0x43
0x46
0x20
0x43
0x41
0x52
0x44
0x00
0x47
0x45
0x4E
0x45
0x52
0x49
0x43
0x00
0x00
0x00
0xFF
0x1A
CISTPL_CONFIG
0x04
0x00
0x04
0xF8
0x0F
The Level 1 version / product information tuple provides the host with the following
information:
• The device supports version 7.1 of the PC Card Specification.
• The Manufacturer String is “CF CARD”
• The Product String is “GENERIC”
The Additional Product Information strings are empty.
The CISTPL_CONFIG tuple provides basic configuration information including the
following:
• Base address of the configuration registers (specified as 0xF8)
• Which configuration registers are present and supported (Configuration
Options Register, Configuration Status Register, Pin Replacement
Register, and Socket and Copy Register are supported).
• Index of the last Configuration Table Entry (set to 0x04).
0x1B
CISTPL_CFTABLE_ENTRY This tuple specifies one particular configuration that the device can be used in. Each
0x0F
configuration has an index number, which is used by the host to select it. This
0xC1
configuration has the following properties:
0x41
• Index is 0x01
0x99
• READY signal is active, and configuration is for I/O and Memory mode.
0x01
• Nominal Vcc is set to be 3.30 volts.
0xB5
• Requests 16 bytes of I/O space, starting at 0x03F8.
0x1E
• Level interrupts, interrupt sharing are supported.
0xA8
• Any interrupt (IRQ0-15) can be used.
0x60
0xF8
• Maximum number of identical cards is set to 8.
0x03
0x0F
0xB0
0xFF
0xFF
0x07
0x1B
CISTPL_CFTABLE_ENTRY This configuration is based on the previous configuration, except that it specifies the
0x03
I/O space can start anywhere.
0x02
0x08
0x2F
0x1B
CISTPL_CFTABLE_ENTRY This tuple specifies one particular configuration that the device can be used in. Each
0x0E
configuration has an index number, which is used by the host to select it. This
0xC3
configuration has the following properties:
Page 26