SA571 Datasheet, PDF (9/11 Pages) NXP Semiconductors – Compandor

SA571
Figure 15 shows the noise performance of the DG cell.
The maximum output level before clipping occurs in the
gain cell is plotted along with the output noise in a 20 kHz
bandwidth. Note that the noise drops as the gain is reduced
for the first 20 dB of gain reduction. At high gains, the signal
to noise ratio is 90 dB, and the total dynamic range from
maximum signal to minimum noise is 110 dB.
+20
0
MAXIMUM
−20
SIGNAL LEVEL
−40 ^110dB
90dB
−60
−80
−100
−40
NOISE IN
20kHz BW
−20
0
VCA GAIN (0dB)
Figure 15. Dynamic Range
Control signal feedthrough is generated in the gain cell by
imperfect device matching and mismatches in the current
sources, I₁ and I₂. When no input signal is present, changing
I_G will cause a small output signal. The distortion trim is
effective in nulling out any control signal feedthrough, but
in general, the null for minimum feedthrough will be
different than the null in distortion. The control signal
feedthrough can be trimmed independently of distortion by
tying a current source to the DG input pin. This effectively
trims I₁. Figure 16 shows such a trim network.
V_CC
R−SELECT FOR
100kW
3.6V
470kW
TO PIN 3 OR 14
Figure 16. Control Signal Feedthrough
Operation Amplifier
The main op amp shown in the chip block diagram is
equivalent to a 741 with a 1.0 MHz bandwidth. Figure 17
shows the basic circuit. Split collectors are used in the input
pair to reduce g_M, so that a small compensation capacitor of
just 10 pF may be used. The output stage, although capable
of output currents in excess of 20 mA, is biased for a low
quiescent current to conserve power. When driving heavy
loads, this leads to a small amount of crossover distortion.
−IN
Q₁
Q₃
I₁
Q₂
Q₄
I₂
+IN
D₁
D₂
C_C
Q₂
Q₆
OUT
Figure 17. Operational Amplifier
ORDERING INFORMATION
Device
Description
Temperature Range
Shipping^†
SA571D
16−Pin Plastic Small Outline (SO−16 WB) Package
−40 to +85°C
47 Units / Rail
SA571DG
16−Pin Plastic Small Outline (SO−16 WB) Package
(Pb−Free)
−40 to +85°C
47 Units / Rail
SA571DR2
16−Pin Plastic Small Outline (SO−16 WB) Package
−40 to +85°C
1000 / Tape & Reel
SA571DR2G
16−Pin Plastic Small Outline (SO−16 WB) Package
(Pb−Free)
−40 to +85°C
1000 / Tape & Reel
SA571N
16−Pin Plastic Dual In−Line Package (PDIP−16)
−40 to +85°C
25 Units / Rail
SA571NG
16−Pin Plastic Dual In−Line Package (PDIP−16)
(Pb−Free)
−40 to +85°C
25 Units / Rail
†For information on tape and reel specifications, including part orientation and tape sizes, please refer to our Tape and Reel Packaging
Specifications Brochure, BRD8011/D.
http://onsemi.com
9