AMIS-30624_13 Datasheet, PDF (7/52 Pages) ON Semiconductor – I2C Micro-stepping Motor Driver

AMIS−30624, NCV70624
Table 5. DC PARAMETERS
Symbol Pin(s)
Parameter
Test Conditions
Min
Typ
Max
Unit
SUPPLY AND VOLTAGE REGULATOR
V_DD
Regulated internal supply
8 V < V_BB < 29 V
4.75
5
5.50
V
(Note 13)
V_ddReset
Digital supply reset level @
V_{DD power down (Note 14)}
4.5
V
I_ddLim
Current limitation
SWITCH INPUT AND HARDWIRE ADDRESS INPUT
Pin shorted to ground
V_BB = 14 V
45
mA
Rt__OFF
Switch OPEN resistance
(Note 15)
10
kW
Rt__ON
Switch ON resistance
SWI HW _{(Note 15)}
Switch to GND or V_BB
2
kW
V_{bb_sw}
V_BB range for guaranteed
operation of SWI and HW
6
29
V
I_{lim_sw}
TEST PIN
Current limitation
Short to GND or V_bat
20
V_BB = 29 V
30
45
mA
V_ihigh
V_ilow
TST
HW_hyst
CHARGE PUMP
V_cp
VCP
C_buffer
C_pump
CPP
CPN
Input level high
Input level low
Hysteresis
Output voltage
External buffer capacitor
External pump capacitor
V_BB = 14 V
V_BB = 14 V
V_BB = 14 V
6 V  V_BB  14 V
14 V  V_BB  30 V
0.7 * V_dd
0.075 * V_dd
V
0.3 * V_dd
V
V
2 * V_BB − 2.5
V
V_BB + 10
V_BB + 15
V
220
470
nF
220
470
nF
MOTION QUALIFICATION MODE OUTPUT (Note 16)
V_OUT
R_OUT
Av
Output voltage swing
SWI Output impedance
Gain = V_SWI / V_BEMF
TestBemf I²C command
Service mode I²C command
Service mode I²C command
PACKAGE THERMAL RESISTANCE VALUES
0 − 4,85
V
2
kW
0.50
Rth_ja
SO
Thermal resistance junction
to ambient (2S2P)
39
K/W
Rth_jp
Rth_ja
SO
Thermal resistance junction
to leads
NQ
Thermal resistance junction
to ambient (2S2P)
Simulated conform
JEDEC JESD51
19
K/W
30
K/W
Rth_jp
NQ
Thermal resistance junction
to leads and exposed pad
0.95
K/W
13. Pin V_DD must not be used for any external supply
14. The RAM content will not be altered above this voltage.
15. External resistance value seen from pin SWI or HW, including 1 kW series resistor. For the switch OPEN, the maximum allowed leakage
current is represented by a minimum resistance seen from the pin.
16. Not applicable for “Product Versions NCV70624DW010G, NCV70624DW010R2G”
http://onsemi.com
7