LC88F85D0A Datasheet, PDF (5/31 Pages) Sanyo Semicon Device – FROM 256K byte, RAM 8K byte on-chip 16-bit 1-chip Microcontroller

LC88F85D0A
Continued from preceding page.
• HOLD mode: Suspends instruction execution and the operation of the peripheral circuits.
1) OSC1, RC, and OSC0 oscillations automatically stop.
2) There are five ways of releasing the HOLD mode:
<1> Setting the reset pin to the low level
<2> Having an interrupt source established at port 0
<3> Having an interrupt source established at SIO0
<4> Having an interrupt source established at UART2
<5> Having an interrupt source established at SEGINT
• HOLDX mode: Suspends instruction execution and the operation of all the circuits except the peripheral circuits
running on OSC0.
1) OSC1 and RC oscillators automatically stop operation.
2) OSC0 retains the state established when the HOLDX mode is entered.
3) There are seven ways of releasing the HOLDX mode:
<1> Setting the reset pin to the low level
<2> Having an interrupt source established at port 0
<3> Having an interrupt source established at SIO0
<4> Having an interrupt source established at UART2
<5> Having an interrupt source established at SEGINT
<6> Having an interrupt source established in the base timer or RTC2 circuit
<7> Having an interrupt source established in the infrared remote control receiver circuit
On-chip debugger function
• Supports software debugging with the microcontroller mounted on the target board.
• Supports source line debugging, tracing, breakpoint manipulation, and realtime display.
• Single-wire communication
Operating temperature
• -20 to +75°C
Package form
• TQFP120 (14×14) (lead-free type)
Development tools
• On-chip debugger: EOCUIF1 + LC88F85D0A
Package Dimensions
unit : mm (typ)
3257A
16.0
14.0
120
1
0.4
0.15
(1.2)
0.125
SANYO : TQFP120(14X14)
No.A1954-5/31