English
Language : 

LC88F85D0A Datasheet, PDF (4/31 Pages) Sanyo Semicon Device – FROM 256K byte, RAM 8K byte on-chip 16-bit 1-chip Microcontroller
LC88F85D0A
• Normal mode: 35 sources (15 modules), 10 vectors
No.
Vector
Interrupt Module
1
08000H
Watchdog timer (1)
2
08004H
Base timer (2)
3
08008H
Timer 0 (2)
4
08018H
Timer 1 (2)/UART2 (4)
5
0801CH
SMIIC0 (1)
6
08020H
Timer 3 (2)/infrared remote control receiver (4)
7
08024H
Timer 4 (1)
8
08030H
ADC (1)/timer 5 (1)
9
08038H
SIO0 (2)
10
0803CH
Port 0 (3)/RTC2 (1)/SEGINT (8)
• LC888300 Compatible mode: 35 sources (15 modules), 13 vectors
No.
Vector
Interrupt Module
1
08000H
Watchdog timer (1)
2
08004H
Base timer (2)
3
08008H
Timer 0 (2)
4
08018H
SIO0 (2)
5
0801CH
Timer 1 (2)
6
08020H
UART2 (4)
7
08024H
Timer 3 (2)
8
08028H
Timer 4 (1)
9
0802CH
Timer 5 (1)
10
08030H
ADC (1)
11
08034H
SMIIC0 (1)
12
08038H
Infrared remote control receiver (4)
13
0803CH
Port 0 (3)/RTC2 (1)/SEGINT (8)
• Priority levels X > H > L
• When interrupts of the same level occur at the same time, an interrupt with a smaller vector address is given priority.
• The number in parentheses indicates the number of sources in a module.
Subroutine stack: 8K-byte RAM area
• Subroutine calls that automatically save the PSW, interrupt vector call: 6 bytes
• Subroutine calls that do not automatically save the PSW: 4 bytes
Multiplication/division instructions
• 16 bits × 16 bits
(18 tCYC execution time)
• 16 bits ÷ 16 bits
(18 to 19 tCYC execution time)
• 32 bits ÷ 16 bits
(18 to 19 tCYC execution time)
■Oscillator circuits
• RC oscillator circuit (internal):
• CF oscillator circuit:
• RC oscillator circuit (external RCR1):
• Crystal oscillator circuit (Rf built-in):
• RC oscillator circuit (external RCR0):
• SLRC oscillator circuit (internal):
For system clock
For system clock (OSC1)
For system clock (OSC1)
For low-speed system clock (OSC0) (option available)
For low-speed system clock (OSC0)
For system clock (used during exception processing)
■System clock frequency divider function
• Can run on low consumption current.
• Supports frequency-dividing of 1/1 to 1/128 of the system clock
Standby function
• HALT mode: Halts instruction execution while allowing the peripheral circuits to continue operation.
1) Oscillation is not halted automatically.
2) HALT mode is released by a system reset or an interrupt .
Continued on next page.
No.A1954-4/31