AMIS-39101 Datasheet, PDF (5/12 Pages) AMI SEMICONDUCTOR – Octal High-Side Driver with Protection

AMIS−39101
ELECTRICAL AND ENVIRONMENTAL RATINGS
Table 3. ABSOLUTE MAXIMUM RATINGS
Symbol
Description
Min.
Max.
Unit
VDDN
Power supply voltage
GND − 0.3
6
V
VS
VS power supply on pins VS1 to VS4, load dump,
Pulse 5b 400 ms
GND − 0.3
35
V
Iout_ON
Maximum output current OUTx pins (Note 3)
The HS driver is switched on
−3000
350
mA
Iout_OFF
Maximum output current OUTx pins (Note 3)
The HS driver is switched off
−350
350
mA
I_OUT_VS Maximum output current VS1, 2, 3, 4 pins
−700
3750
mA
Vcapa1 DC voltage on pin CAPA1
0
VS+16.5
V
Vdig_in Voltage on digital inputs CLK, PDB, WR, DIN
−0.3
VDDN+0.3
V
V_ESD
Pins that connect the application (pins VS1..4 and Out1..8) (Note 4)
All other pins (Note 4)
−4
+4
kV
−2
+2
kV
V_ESD
Tj
ESD according charged device model (Note 5)
Junction temperature (T<100 hours)
−750
−40
+750
V
175
°C
Tmr
Ambient temperature under bias
−40
85
°C
Stresses exceeding Maximum Ratings may damage the device. Maximum Ratings are stress ratings only. Functional operation above the
Recommended Operating Conditions is not implied. Extended exposure to stresses above the Recommended Operating Conditions may affect
device reliability.
3. The power dissipation of the chip must be limited not to exceed the maximum junction temperature Tj.
4. According to HBM standard MIL−STD−883 method 3015.7.
5. According to norm EOS/ESD−STM5.3.1−1999 robotic mode.
Thermal Characteristics
Table 4. THERMAL CHARACTERISTICS OF THE PACKAGE
Symbol
Description
R_{th(vj−a)}
Thermal resistance from junction to ambient in power−SO28 package
Conditions
In free air
Value
145
Unit
K/W
Table 5. THERMAL CHARACTERISTICS OF THE AMIS−39101 ON A PCB
PCB Design
Conductivity − Top and Bottom Layer
Two layer (35 mm) Copper planes according to Figure 4 + 25% copper for the remaining areas
Two layer (35 mm) Copper planes according to Figure 4 + 0% copper for the remaining areas
Four layer JEDEC: 25% copper coverage
EIA/JESD51−7
One layer JEDEC: 25% copper coverage
EIA/JESD51−3
6. These values are informative only.
Rthja (Note 6)
Unit
24
K/W
53
K/W
25
K/W
46
K/W
http://onsemi.com
5