NOIL2SM1300A Datasheet, PDF (41/44 Pages) ON Semiconductor – LUPA1300-2: High Speed CMOS Image Sensor

NOIL2SM1300A
Glass Lid
The LUPA1300-2 monochrome and color image sensor
uses a glass lid without any coatings. Figure 36 shows the
transmission characteristics of the glass lid.
As shown in Figure 36, no infrared attenuating color filter
glass is used. A filter must be provided in the optical path
when color devices are used (source:
http://www.pgo−online.com).
Figure 36. Transmission Characteristics of the Glass Lid
HANDLING PRECAUTIONS
For proper handling and storage conditions, refer to the ON Semiconductor application note AN52561.
LIMITED WARRANTY
ON Semiconductor’s Image Sensor Business Unit
warrants that the image sensor products to be delivered
hereunder, if properly used and serviced, will conform to
Seller’s published specifications and will be free from
defects in material and workmanship for two (2) years
following the date of shipment. If a defect were to manifest
itself within two (2) years period from the sale date,
ON Semiconductor will either replace the product or give
credit for the product.
Return Material Authorization (RMA)
ON Semiconductor packages all of its image sensor
products in a clean room environment under strict handling
procedures and ships all image sensor products in ESD-safe,
clean-room-approved shipping containers. Products
returned to ON Semiconductor for failure analysis should be
handled under these same conditions and packed in its
original packing materials, or the customer may be liable for
the product.
ACCEPTANCE CRITERIA SPECIFICATION
The Product Acceptance Criteria is available on request. This document contains the criteria to which the LUPA1300−2 is
tested before being shipped.
APPLICATION NOTE REFERENCES
• AN54468: Interfacing the LUPA1300-2 with FPGA
This application note describes the interface between the
LUPA1300-2 and the FPGA, as implemented in the
LUPA1300-2 demonstration kit. It also provides an
overview of the architecture of the demonstration kit and the
method used to synchronize channels.
• AN54214: High Speed Layout Guidelines for the
LUPA1300-2 Image Sensor
• AN54598: Pixel Remapping Implementation in
LUPA1300-2 Demonstration Kit
This application note explains the remapping technique
implemented in LUPA1300-2 demonstration system to align
non consecutive pixels readout to consecutive pixels for
creating proper images. It also describes the remapping
method during Reverse-X/Y readout and subsampling
modes of operation.
http://onsemi.com
41