NOIL2SM1300A Datasheet, PDF (31/44 Pages) ON Semiconductor – LUPA1300-2: High Speed CMOS Image Sensor

NOIL2SM1300A
The reset levels are configured through external (power)
pins. In master mode, the time stamps of the double and
triple slope resets are configured in a method similar to
configuring the exposure time. The time stamps are enabled
through the registers seqmode1[5] and seqmode1[6], and
their values are expressed in line or clock cycles in the
registers reg_tint_ds_timer and reg_tint_ts_timer.
Figure 30. Triple Slope Timing in Master Mode
In slave mode, the values of res_length, tint_timer,
tint_DS_timer, and tint_TS_timer in the configuration
registers are ignored. You have full control through the pins
int_time, int_time_ds, and int_time_ts. You must configure
the multiple slope parameters for the application and
interpret the pixel data accordingly.
Figure 31. Triple Slope Timing in Slave Mode
http://onsemi.com
31