NOIL2SM1300A Datasheet, PDF (1/44 Pages) ON Semiconductor – LUPA1300-2: High Speed CMOS Image Sensor

NOIL2SM1300A
LUPA1300-2: High Speed
CMOS Image Sensor
Features
• 1280 x 1024 Active Pixels
• 14 mm X 14 mm Square Pixels
• 1.4” Optical Format
• Monochrome or Color Digital Output
• 500 fps Frame Rate
• On-Chip 10-Bit ADCs
• 12 LVDS Serial Outputs
• Random Programmable ROI Readout
• Pipelined and Triggered Global Shutter
• On-Chip Column FPN Correction
• Serial Peripheral Interface (SPI)
• Limited Supplies: Nominal 2.5 V and 3.3 V
• −50°C to +85°C Operational Temperature Range
• 168-Pin mPGA Package
• Power Dissipation: 1350 mW
• These Devices are Pb−Free and are RoHS Compliant
Applications
• High Speed Machine Vision
• Motion Analysis
• Intelligent Traffic System
• Medical Imaging
• Industrial Imaging
Description
The LUPA1300-2 is an integrated SXGA high speed, high
sensitivity CMOS image sensor. This sensor targets high
speed machine vision and industrial monitoring
applications. The LUPA1300-2 sensor runs at 500 fps and
has triggered and pipelined shutter modes. It packs 24
parallel 10-bit A/D converters with an aggregate conversion
rate of 740 MSPS. On-chip digital column FPN correction
enables the sensor to output ready to use image data for most
applications. To enable simple and reliable system
integration, the 12 channels, 1 sync channel, 8 Gbps, and
LVDS serial link protocol supports skew correction and
serial link integrity monitoring.
The peak responsivity of the 14 mm x 14 mm 6T pixel is
63 DN/nJ/cm². Dynamic range is measured at 57 dB. In full
frame video mode, the sensor consumes 1350 mW from the
2.5 V and 3.3 V power supplies. The sensors integrate A/D
http://onsemi.com
Figure 1. LUPA1300−2 Die Photo
conversion, on-chip timing for a wide range of operating
modes, and has an LVDS interface for easy system
integration.
By removing the visually disturbing column patterned
noise, this sensor enables building a camera without any
offline correction or the need for memory. In addition, the
on-chip column FPN correction is more reliable than an
offline correction, because it compensates for supply and
temperature variations. The sensor requires one master
clock for operations up to 500 fps.
The LUPA1300-2 is housed in a 168 pin mPGA package
and is available in a monochrome version and Bayer (RGB)
patterned color filter array. The monochrome version is also
available without glass. Contact your local
ON Semiconductor office.
© Semiconductor Components Industries, LLC, 2014
1
June, 2014 − Rev. 10
Publication Order Number:
NOIL2SM1300A/D