AR0230 Datasheet, PDF (30/36 Pages) ON Semiconductor – Full HD Digital Image Sensor

AR0230CS: 1/2.7-Inch 2.1 Mp/Full HD Digital Image Sensor
Electrical Specifications
Table 18: Line Interleaved HiSPi HiVcm
Definition
Condition
Symbol
Voltage
Min
Typ
Digital Operating Current
Streaming 1080p30
IDD
1.8
185
230
Analog Operating Current
Streaming 1080p30
IDD_IO
2.8
20
36
Pixel Supply Current
Streaming 1080p30
IAA
2.8
1
3.3
PLL Supply Current
Streaming 1080p30
IAA_PIX
2.8
7
8.2
SLVS Supply Current
Streaming 1080p30
IDD_PLL
1.8
10
20
Power (mW) 429.4
583
Note:
Operating currents are measured in mA at the following conditions:
- VAA = VAA_PIX = VDD_PLL = 2.8 V
- VDD= VDD_IO = 1.8 V
- VDD_SLVS = 1.8 V
- PLL Enabled and PIXCLK = 74.25 MHz
- 4-lane HiSPi mode
- TA = 25°C
Max
265
55
7
9.5
30
717.2
HiSPi Electrical Specifications
The ON Semiconductor AR0230CS sensor supports both SLVS and HiVCM HiSPi modes.
Refer to the High-Speed Serial Pixel (HiSPi) Interface Physical Layer Specification
v2.00.00 for electrical definitions, specifications, and timing information. The VDD_SLVS
supply in this datasheet corresponds to VDD_TX in the HiSPi Physical Layer Specifica-
tion. Similarly, VDD is equivalent to VDD_HiSPi as referenced in the specification. The
DLL as implemented on AR0230CS is limited in the number of available delay steps and
differs from the HiSPi specification as described in this section.
Table 19:
Channel Skew
Measurement Conditions: VDD_HiSPi = 1.8V;VDD_HiSPi_TX = 0.4V; Data Rate =480 Mbps; DLL set to 0
Data Lane Skew in Reference to Clock
tCHSKEW1PHY
-150
ps
AR0230CS/D Rev. 8, Pub. 11/15 EN
30
©Semiconductor Components Industries, LLC, 2015.