CM2009-05CP Datasheet, PDF (3/8 Pages) ON Semiconductor – VGA or DVI-I Port Companion Circuit

CM2009-05CP
PIN DESCRIPTIONS
LEAD(s)
A1
A2
A3
A4
A5
B1
B2
B3
B4
C1
C2
C3
C4
C5
NAME
GND
VIDEO_1
VIDEO_2
VIDEO_3
V_CC
DDC_OUT1
DDC_OUT2
SYNC_OUT1
DESCRIPTION
Ground reference supply pin.
Video signal ESD protection channel. This pin is typically tied one of the video lines between the
controller device and the video connector.
Video signal ESD protection channel. This pin is typically tied one of the video lines between the
controller device and the video connector.
Video signal ESD protection channel. This pin is typically tied one of the video lines between the
controller device and the video connector.
This is a supply input for the SYNC_1 and SYNC_2 level shifters, video protection and the DDC
circuits.
DDC signal output. Connects to the DDC logic.
DDC signal output. Connects to the DDC logic.
Sync signal buffer output. Connects to the monitor Sync logic.¹
SYNC_OUT2 Sync signal buffer output. Connects to the monitor Sync logic.¹
DDC_IN1
DDC_IN2
LV_EN
SYNC_IN1
DDC signal input. Connects to the video connector side of one of the DDC lines.
DDC signal input. Connects to the video connector side of one of the DDC lines.
Disables the Sync buffer outputs when low.
Sync signal buffer input. Connects to the video connector side of one of the Sync lines.²
SYNC_IN2 Sync signal buffer input. Connects to the video connector side of one of the Sync lines.²
Note 1: Can also be connected to the VGA connector side if used for a source device.
Note 2: Can also be used to connect to the Video Chip Sync Logic if it is used for a source device.
Ordering Information
PART NUMBERING INFORMATION
Bumps
14
Package
CSP
Note 1: Parts are shipped in Tape and Reel form.
Ordering Part Number¹
CM2009-05CP
Part Marking
TJ
Rev. P2 | Page 3 of 8 | www.onsemi.com