|
AMIS30532C5321G Datasheet, PDF (17/29 Pages) ON Semiconductor – Micro-Stepping Motor Driver | |||
|
◁ |
AMISâ30532
Speed and Load Angle Output
The SLAâpin provides an output voltage that indicates the
level of the Backâe.m.f. voltage of the motor. This
Backâe.m.f. voltage is sampled during every soâcalled âcoil
ICOIL
current zero crossingsâ. Per coil, two zeroâcurrent positions
exist per electrical period, yielding in total four zeroâcurrent
observation points per electrical period.
V BEMF
t
ICOIL
Previous
M icro âstep
ZOOM
Coil Current Zero Crossing
Current Decay
Zero Current
Next
M icr o âstep
t
V COIL
V BB
Voltage Transient
|VBEMF |
t
Figure 14. Principle of Bemf Measurement
Because of the relatively high recirculation currents in the
coil during current decay, the coil voltage VCOIL shows a
transient behavior. As this transient is not always desired in
application software, two operating modes can be selected
by means of the bit <SLAT> (see âSLAâtransparencyâ in
see SPI Control Parameter Overview). The SLA pin shows
in âtransparent modeâ full visibility of the voltage transient
behavior. This allows a sanityâcheck of the speedâsetting
versus motor operation and characteristics and supply
voltage levels. If the bit âSLATâ is cleared, then only the
voltage samples at the end of each coil current zero crossing
are visible on the SLAâpin. Because the transient behavior
of the coil voltage is not visible anymore, this mode
generates smoother Back e.m.f. input for postâprocessing,
e.g. by software.
In order to bring the sampled Back e.m.f. to a descent
output level (0 V to 5 V), the sampled coil voltage VCOIL is
divided by 2 or by 4. This divider is set through an SPI bit
<SLAG>. (see SPI Control Parameter Overview)
The following drawing illustrates the operation of the
SLAâpin and the transparencyâbit. âPWMshâ and âICOIL =
0â are internal signals that define together with SLAT the
sampling and hold moments of the coil voltage.
http://onsemi.com
17
|
▷ |