LMH6321 Datasheet, PDF (5/21 Pages) National Semiconductor (TI) – 300 mA High Speed Buffer with Adjustable Current Limit

±5V Electrical Characteristics (Continued)
The following specifications apply for Supply Voltage = ±5V, V_CM = 0, R_L ≥ 100 kΩ and R_S = 50Ω, C_L Open, unless otherwise
noted. Boldface limits apply for T_A = T_J = T_MIN to T_MAX; all other limits T_A = T_J = 25˚C.
Symbol
Parameter
Conditions
Min
Typ
Max Units
V/I Section
CLV_OS
Current Limit Input Offset
Voltage
R_L = 1 kΩ, GND = 0V
2.7
+5
±5.0
mV
CLI_B
Current Limit Input Bias
Current
R_L = 1 kΩ, C_L = 0V
−0.5
−0.2
µA
−0.6
CL
CMRR
Current Limit Common Mode
Rejection Ratio
R_L = 1 kΩ, GND = −3V to +4V
60
65
dB
56
Note 1: Absolute Maximum Ratings indicate limits beyond which damage to the device may occur. Operating Ratings indicate conditions for which the device is
intended to be functional, but specific performance is not guaranteed. For guaranteed specifications and the test conditions, see the Electrical Characteristics Table.
Note 2: Human Body Model is 1.5 kΩ in series with 100 pF. Machine Model is 0Ω in series with 200 pF.
Note 3: If the input-output voltage differential exceeds ±5V, internal clamping diodes will turn on. The current through these diodes should be limited to 5 mA max.
Thus for an input voltage of ±15V and the output shorted to ground, a minimum of 2 kΩ should be placed in series with the input.
Note 4: The maximum continuous current must be limited to 300 mA. See the Application section for more details.
Note 5: For the condition where the C_L pin is left open the output current should not be continuous, but instead, should be limited to low duty cycle pulse mode such
that the RMS output current is less than or equal to 300 mA.
Note 6: Soldered to PC board with copper foot print equal to DAP size. Natural convection (no air flow). Board material is FR-4.
Note 7: V_IN = + or −4V at T_J = −40˚C.
Note 8: The maximum power dissipation is a function of T_J(MAX), θ_JA, and T_A. The maximum allowable power dissipation at any ambient temperature is
P_D = T_J(MAX)–T_A)/θ_JA. See Thermal Management section of the Application Hints.
Ordering Information
Package
8-Pin PSOP
7-Pin TO-263
Part Number
LMH6321MR
LMH6321MRX
LMH6321TS
LMH6321TSX
Package Marking
LMH6321MR
LMH6321TS
Transport Media
95 Units/Rail
2.5k Units Tape and Reel
45 Units/Rail
500 Units Tape and Reel
NSC Drawing
MRA08A
TS7B
5
www.national.com