THS4511-SP Datasheet, PDF (19/25 Pages) Texas Instruments – RAD-TOLERANT CLASS V, WIDEBAND, FULLY DIFFERENTIAL AMPLIFIER

www.ti.com
Layout Recommendations
It is recommended to follow the layout of the external
components near the amplifier, ground plane
construction, and power routing of the EVM as
closely as possible. General guidelines are:
1. Signal routing should be direct and as short as
possible into and out of the operational amplifier
circuit.
2. The feedback path should be short and direct
avoiding vias.
3. Ground or power planes should be removed from
directly under the amplifier’s input and output
pins.
4. An output resistor is recommended on each
output, as near the output pin as possible.
THS4511–SP
SLOS538A – SEPTEMBER 2007 – REVISED OCTOBER 2007
5. Two 10 μF and two 0.1 μF power-supply
decoupling capacitors should be placed as near
the power-supply pins as possible.
6. Two 0.1 μF capacitors should be placed between
the CM input pins and ground. This limits noise
coupled into the pins. One each should be placed
to ground near pin 4 and pin 9.
7. It is recommended to split the ground pane on
layer 2 (L2) as shown below and to use a solid
ground on layer 3 (L3). A single-point connection
should be used between each split section on L2
and L3.
8. A single-point connection to ground on L2 is
recommended for the input termination resistors
R1 and R2. This should be applied to the input
gain resistors if termination is not used.
Copyright © 2007, Texas Instruments Incorporated
Product Folder Link(s): THS4511–SP
Submit Documentation Feedback
19