DS92LV010AEP Datasheet, PDF (1/12 Pages) National Semiconductor (TI) – Bus LVDS 3.3/5.0V Single Transceiver

DS92LV010AEP
OBSOLETE
June 15, 2009
Bus LVDS 3.3/5.0V Single Transceiver
General Description
The DS92LV010AEP is one in a series of transceivers de-
signed specifically for the high speed, low power proprietary
bus backplane interfaces. The device operates from a single
3.3V or 5.0V power supply and includes one differential line
driver and one receiver. To minimize bus loading the driver
outputs and receiver inputs are internally connected. The log-
ic interface provides maximum flexibility as 4 separate lines
are provided (DIN, DE, RE, and ROUT). The device also fea-
tures flow through which allows easy PCB routing for short
stubs between the bus pins and the connector. The driver has
10 mA drive capability, allowing it to drive heavily loaded
backplanes, with impedance as low as 27 Ohms.
The driver translates between TTL levels (single-ended) to
Low Voltage Differential Signaling levels. This allows for high
speed operation, while consuming minimal power with re-
duced EMI. In addition the differential signaling provides com-
mon mode noise rejection of ±1V.
The receiver threshold is ±100mV over a ±1V common mode
range and translates the low voltage differential levels to stan-
dard (CMOS/TTL) levels.
ENHANCED PLASTIC
Features
■ ^{Bus LVDS Signaling (BLVDS)}
■ ^{Designed for Double Termination Applications}
■ ^{Balanced Output Impedance}
■ ^{Lite Bus Loading 5pF typical}
■ ^{Glitch free power up/down (Driver disabled)}
■ ^{3.3V or 5.0V Operation}
■ ^{±1V Common Mode Range}
■ ^{±100mV Receiver Sensitivity}
■ ^{High Signaling Rate Capability (above 100 Mbps)}
■ ^{Low Power CMOS design}
■ ^{Product offered in 8 lead SOIC package}
Applications
Selected Military Applications
Selected Avionics Applications
• Extended Temperature Performance of -40°C to +85°C
• Baseline Control - Single Fab & Assembly Site
• Process Change Notification (PCN)
• Qualification & Reliability Data
• Solder (PbSn) Lead Finish is standard
• Enhanced Diminishing Manufacturing Sources (DMS)
Support
Ordering Information
PART NUMBER
DS92LV010ATMEP
(Notes 1, 2)
VID PART NUMBER
V62/04740-01
TBD
NS PACKAGE NUMBER (Note 3)
M08A
TBD
Note 1: For the following (Enhanced Plastic) version, check for availability: - DS92LV010ATMXEP Parts listed with an "X" are provided in Tape & Reel and
parts without an "X" are in Rails.
Note 2: FOR ADDITIONAL ORDERING AND PRODUCT INFORMATION, PLEASE VISIT THE ENHANCED PLASTIC WEB SITE AT: www.national.com/
mil
Note 3: Refer to package details under Physical Dimensions
Connection Diagram
20119301
See NS Package Number M08A
TRI-STATE^® is a registered trademark of National Semiconductor Corporation.
© 2009 National Semiconductor Corporation 201193
201193 Version 3 Revision 1 Print Date/Time: 2009/06/15 11:42:19
www.national.com