CSTCE12M0G55Z-R0 Datasheet, PDF (16/45 Pages) Murata Manufacturing Co., Ltd. – Ceramic Resonators (CERALOCKr)

!Note • Please read rating and !CAUTION (for storage, operating, rating, soldering, mounting and handling) in this catalog to prevent smoking and/or burning, etc.
• This catalog has only typical specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering.
Notice for Automotive
P16E.pdf
Nov.22,2012
c Soldering and Mounting (CSTCV/CSACV Series)
1. Soldering
(1) Reflow soldering
Please mount component on a circuit board by reflow
soldering. Flow soldering is not acceptable.
Recommendable Flux and Solder
Please use rosin based flux,
Flux
not water soluble flux.
Solder
Please use solder (Sn-3.0Ag-0.5Cu) under
the following conditions: Standard thickness
of soldering paste: 0.10 to 0.15mm.
Recommendable Soldering Profile
Pre-heating
150 to 180°C
Heating
220°C min.
Peak Temperature
upper limit: 260°C
lower limit: 245°C
60 to 120s
30 to 60s
1s max.
5s max.
Temperature shall be measured on the surface of component.
(2) Soldering with Iron
If compelled to mount the component by using soldering
iron, please do not directly touch the component with the
soldering iron. The component terminals or electrical
characteristics may be damaged if excessive thermal
stress is applied.
Recommendable Soldering with Iron
Heating of the soldering iron
350°C max.
Watt
30W max.
Shape of the soldering iron
ø3mm max.
Soldering Time
5s max. at one terminal
Solder
Sn-3.0Ag-0.5Cu
(3) Other
Do not reuse components removed from a circuit board
after soldering.
(4) Conditions for Placement Machines
The component is recommended with placement
machines that employ optical placement capabilities. The
component may be damaged by excessive mechanical
force. Please make sure that you have evaluated by
using placement machines before going into mass
production. Do not use placement machines that utilize
mechanical positioning. Please contact Murata for details
beforehand.
260
Peak
245
220
180
Heating
(220°C min.)
150
Pre-heating
(150 to 180°C)
Gradual
Cooling
60 to 120s
30 to 60s
2. Wash
(1) Cleaning Solvents
HCFC, Isopropanol, Tap water, Demineralized water,
Cleanthrough750H, Pine alpha 100S, Techno care FRW
(2) Temperature Difference : dT *1
dTV60°C (dT=Component-solvent)
*1 ex. If the component is immersed at +90°C into
cleaning solvent at +60°C, then dT=30°C.
14
Continued on the following page.