0438790058 Datasheet, PDF (5/6 Pages) Molex Electronics Ltd. – MINI-FIT JR. CONNECTOR SYSTEM COMPLIANT PIN INTERFACE (CPI) (WIRE TO PCB & PCB TO PCB)

PRODUCT SPECIFICATION
Duration: 2 hours in each X-Y-Z
axis.
5.2 MECHANICAL PERFORMANCE (continued)
Section Item
5.2.12 Mechanical Shock
Test Condition
50 G’s with three saw tooth wave
form shocks in each X-Y-Z axis
Discontinuity not greater
than 1 µsecond.
Requirement
Contact Res. Change =
20 mΩ max.
Discontinuity not greater
than 1 µsecond
5.3 ENVIRONMENTAL PERFORMANCE
Section Item
5.3.1
Cold Resistance
Test Condition
-40± -3°C for 96 hrs.
Requirement
Appearance: No damage
5.3.2
5.3.3
5.3.4
5.3.5
Thermal Shock
Thermal Aging
Humidity (Steady
State)
Immunity to Fretting
Corrosion
Mate connectors, expose to 10
cycles of: -55 +0-3°C for 30
minutes
+105± 10°C for 5 minutes max.
Mate connectors, expose to 240
hours at 1-5 ±2°C
Mate connectors, expose to a
temperature of 60±2°C with a
relative humidity of 90% to 95% for
96 hours.
Mate connectors, expose to 500
cycles with a max. transition time
of 5 minutes between extremes.
+25±10°C for 30 minutes
+70+3/-0°C for 30 minutes
Contact Res. Change
=20mΩ max.
Appearance: No damage
Contact Res. Change
=20mΩ max.
Appearance: No damage
Contact Res. Change
=1.0 mΩ max.
Appearance: No damage
Contact Res. Change =
20 mΩ max.
Dielectric withstanding
voltage: No breakdown
Insul res. 1000MΩ min
Appearance: No damage
Contact Res. Change:
=20mΩ max.
REVISION: ECR/ECN INFORMATION:
5
EC No:UCP2013-0251
DATE: ^201207/19
DOCUMENT NUMBER:
PS-43879-001
TITLE:
PRODUCT SPECIFICATION
SHEET No.
MINI-FIT JR. CONNECTOR SYSTEM
COMPLIANT PIN INTERFACE (CPI)
5 of 6
CREATED / REVISED BY:
CHECKED BY:
APPROVED BY:
NNGUYEN
BELL
SMITH-ROEMER
FILENAME: PS43879.DOC