0438790058 Datasheet, PDF (3/6 Pages) Molex Electronics Ltd. – MINI-FIT JR. CONNECTOR SYSTEM COMPLIANT PIN INTERFACE (CPI) (WIRE TO PCB & PCB TO PCB)

PRODUCT SPECIFICATION
5.0 PERFORMANCE
5.1 ELECTRICAL PERFORMANCE
Section
5.1.1
5.1.2
5.1.3
5.1.4
Item
Initial Contact Resistance (low level)
Insulation Resistance
Dielectric Strength
Compliant Pin Interface Resistance
Test Condition
Mate connectors,
measure by dry circuit,
20mV max., 100mA.
Wire resistance shall
be removed from the
measured value.
Mate connectors, apply
500V AC for 1 minute
adjacent terminal or
ground.
Mate connectors, apply
1500V AC for 1 minute
between adjacent
terminal or ground.
Insert individual
Compliant Pin terminal
into printed circuit
board.
Requirement
10 mΩ max.
1000 MΩ min.
No breakdown.
1.0 mΩ max.
REVISION: ECR/ECN INFORMATION:
5
EC No:UCP2013-0251
DATE: ^201207/19
DOCUMENT NUMBER:
PS-43879-001
TITLE:
PRODUCT SPECIFICATION
SHEET No.
MINI-FIT JR. CONNECTOR SYSTEM
COMPLIANT PIN INTERFACE (CPI)
3 of 6
CREATED / REVISED BY:
CHECKED BY:
APPROVED BY:
NNGUYEN
BELL
SMITH-ROEMER
FILENAME: PS43879.DOC