455600160 Datasheet, PDF (27/27 Pages) Molex Electronics Ltd. – 0.8MM HANDYLINK 16 CKT CRADLE CONN. ASSY PERPENDICULAR TO PCB

HANDYLINK™
APPLICATION SPECIFICATION
7.0 Electrical Recommendations
7.1 Power Considerations
Please see the Product Specification, PS-44828-001, for the nominal electrical specifications. For applications where the sustained
electrical power usage requirements exceed the limits stated in the product specification, the use of multiple circuits is suggested.
When the end-application is likely to encounter salt spray conditions, potential differences exceeding 4VDC should be separated by
more than one terminal position (i.e. 1.6mm or more) to avoid galvanic corrosion between circuits.
7.2 High Speed Signal Transmission
Testing has shown that under the USB 2.0 Specification environment for connector components and cable assemblies (200 and
500 picosecond rise times), the HandyLink connectors perform within specification for both differential and common-mode impedance.
Full compliance testing on finished cable assemblies will have to be undertaken to verify the performance level of the finished
product.
Contact Molex for further assistance regarding high speed signal transmission applications.
27 _REVISION:
ECR/ECN INFORMATION:
B
EC No: UCP2009-1982
DATE: 2009/02/09
DOCUMENT NUMBER:
SD-45560-001
TITLE:
APPLICATION SPECIFICATION
HANDYLINK™I/O CONNECTOR SYSTEM
SHEET No.
27 of 27
CREATED / REVISED BY:
M. Simmel/D. Morgan
CHECKED BY:
M. Ibarra
APPROVED BY:
S. Miller
TEMPLATE FILENAME: PRODUCT_SPEC[SIZE_A](V.1).DOC