455600160 Datasheet, PDF (21/27 Pages) Molex Electronics Ltd. – 0.8MM HANDYLINK 16 CKT CRADLE CONN. ASSY PERPENDICULAR TO PCB

HANDYLINK™
APPLICATION SPECIFICATION
Supplemental alignment posts must be longer than the protrusion of the plug connector posts from the base surface of the cup-style
receptacle. Further, the alignment posts’ centerlines must lie in the same plane as the centerlines of the plug connector posts to
provide the greatest benefits. Guide ribs are necessary to prevent front-to back rocking motion as the device is loaded into the cup-
style receptacle.
NOTE: The fastening of the cup-style receptacle to the over-molded plug must be kept tight to avoid misalignment. If this is not
achieved, excessive wear between the connector housings and/or electrical discontinuities may occur.
21 _REVISION:
ECR/ECN INFORMATION:
B
EC No: UCP2009-1982
DATE: 2009/02/09
DOCUMENT NUMBER:
SD-45560-001
TITLE:
APPLICATION SPECIFICATION
HANDYLINK™I/O CONNECTOR SYSTEM
SHEET No.
21 of 27
CREATED / REVISED BY:
M. Simmel/D. Morgan
CHECKED BY:
M. Ibarra
APPROVED BY:
S. Miller
TEMPLATE FILENAME: PRODUCT_SPEC[SIZE_A](V.1).DOC