455600160 Datasheet, PDF (19/27 Pages) Molex Electronics Ltd. – 0.8MM HANDYLINK 16 CKT CRADLE CONN. ASSY PERPENDICULAR TO PCB

HANDYLINK™
APPLICATION SPECIFICATION
o Contouring with a Lip
To provide mechanical support for torque out of the axial plane of the connectors, the over-mold must be designed to mimic the
outer surfaces of the end product and include a lip such as illustrated below. NOTE: The axial clearance condition between the
connectors noted in section 4.2 must be maintained.
Off-axis
Torque
directions
Surfaces are contoured
to mimic the end product
Over-molded lip
Figure 13. Example of an over-mold with contouring and a lip
This type of design will provide support for the end-user to hold the product by the connector or where a heavy or stiff accessory cable
is used.
19 _REVISION:
B
ECR/ECN INFORMATION:
EC No: UCP2009-1982
DATE: 2009/02/09
TITLE:
APPLICATION SPECIFICATION
HANDYLINK™I/O CONNECTOR SYSTEM
SHEET No.
19 of 27
DOCUMENT NUMBER:
SD-45560-001
CREATED / REVISED BY:
M. Simmel/D. Morgan
CHECKED BY:
M. Ibarra
APPROVED BY:
S. Miller
TEMPLATE FILENAME: PRODUCT_SPEC[SIZE_A](V.1).DOC