JAN2N6782 Datasheet, PDF (9/9 Pages) Microsemi Corporation – This family of 2N6782, 2N6784 and 2N6786 switching transistors are military qualified up to the JANTXV level for high-reliability applications.

2N6782, 2N6784 and 2N6786
PACKAGE DIMENSIONS
Symbol
CD
CH
HD
LC
LD
LL
LU
L1
L2
P
Q
TL
TW
r
α
Dimensions
Inch
Millimeters
Min
Max
Min
Max
0.305 0.335
7.75
8.51
0.160 0.180
4.06
4.57
0.335 0.370
8.51
9.40
0.200 TP
5.08 TP
0.016 0.021
0.41
0.53
0.500 0.750 12.70 19.05
0.016 0.019
0.41
0.48
0.050
1.27
0.250
6.35
.100
2.54
0.050
1.27
0.029 0.045
0.74
1.14
0.028 0.034
0.72
0.86
0.010
0.25
45° TP
45° TP
Note
6
7, 8
7, 8
7, 8
7, 8
7, 8
5
4
3
2
9
6
NOTES:
1. Dimensions are in inches. Millimeters are given for general information only.
2. Beyond radius (r) maximum, J shall be held for a minimum length of .011 (0.028 mm).
3. Dimension TL measured from maximum HD.
4. Outline in this zone is not controlled.
5. Dimension CD shall not vary more than .010 (0.25 mm) in zone P. This zone is controlled for automatic handling.
6. Leads at gauge plane .054 +.001, -.000 (1.37 +0.03, -0.00 mm) below seating plane shall be within .007 (0.18 mm) radius
of true position (TP) at maximum material condition (MMC) relative to tab at MMC.
7. LU applies between L1 and L2. LD applies between L2 and L minimum. Diameter is uncontrolled in L1 and beyond LL
minimum.
8. All three leads.
9. Radius (r) applies to both inside corners of tab.
10. Drain is electrically connected to the case.
11. In accordance with ASME Y14.5M, diameters are equivalent to Φx symbology.
T4-LDS-0064, Rev. 3 (121467)
©2012 Microsemi Corporation
Page 9 of 9