JAN2N6766 Datasheet, PDF (9/9 Pages) Microsemi Corporation – N-CHANNEL MOSFET Qualified per MIL-PRF-19500/543

2N6764, 2N6766, 2N6768 and 2N6770
PACKAGE DIMENSIONS
NOTE:
1. Dimensions are in inches.
DIM
INCHES
MIN MAX
2. Millimeters are given for general information only.
A
-
0.875
3. These dimensions should be measured at points .050 _{B 0.060 0.135}
inch (1.27 mm) and .055 inch (1.40 mm) below the
C 0.250 0.360
seating plane. When gauge is not used measurement _{D 0.312 0.500}
will be made at the seating plane.
D2
-
0.050
4. The seating plane of the header shall be flat within
.001 inch (0.03 mm) concave to .004 inch (0.10 mm)
E
0.057 0.063
0.038 0.043
convex inside a .930 inch (23.62 mm) diameter circle F 0.131 0.188
on the center of the header and flat within .001 inch
G 1.177 1.197
(0.03 mm) concave to .006 inch (0.15 mm) convex
H 0.655 0.675
overall.
J 0.205 0.225
5. These dimensions pertain to the 2N6764 and 2N6766 ^{K 0.420 0.440}
types.
L 0.495 0.525
6. These dimensions pertain to the 2N6768 and 2N6770 ^{M 0.151 0.161}
types.
7. Mounting holes shall be deburred on the seating plane side.
8. Drain is electrically connected to the case.
9. In accordance with ASME Y14.5M, diameters are equivalent to Φx symbology.
MILLIMETERS
MIN
MAX
-
22.23
1.52
3.43
6.35
9.15
7.92 12.70
-
1.27
1.45
1.60
0.97
1.10
3.33
4.78
29.90 30.40
16.64 17.15
5.21
5.72
10.67 11.18
12.57 13.3
3.84
4.09
NOTES
(3)
DIA. (5)
DIA. (6)
Radius
Radius
DIA. (7)
SCHEMATIC
T4-LDS-0101, Rev. 3 (121466)
©2012 Microsemi Corporation
Page 9 of 9