HAL1000UT-A Datasheet, PDF (5/30 Pages) Micronas – Programmable Hall Switch

DATA SHEET
HAL 1000
1.3. Marking Code
The HAL1000 has a marking on the package surface
(branded side). This marking includes the name of the
sensor and the temperature range.
Type
HAL 1000
Temperature Range
A
K
1000A
1000K
1.4. Operating Junction Temperature Range (T_J)
The Hall sensors from Micronas are specified to the
chip temperature (junction temperature T_J).
A: TJ = −40 °C to +170 °C
K: TJ = −40 °C to +140 °C
The relationship between ambient temperature (T_A)
and junction temperature is explained in Section 4–1
on page 22.
1.5. Hall Sensor Package Codes
HALxxxxPA-T
Temperature Range: A or K
Package: UT for TO92UT
Type: 1000
Example: HAL1000UT-K
→ Type:
1000
→ Package:
TO92UT
→ Temperature Range: T_J = −40°C to +140°C
Hall sensors are available in a wide variety of packag-
ing versions and quantities. For more detailed informa-
tion, please refer to the brochure: “Hall Sensors:
Ordering Codes, Packaging, Handling”.
1.6. Solderability and Welding
Solderability
During soldering reflow processing and manual
reworking, a component body temperature of 260 °C
should not be exceeded.
Welding
Device terminals should be compatible with laser and
resistance welding. Please note that the success of
the welding process is subject to different welding
parameters which will vary according to the welding
technique used. A very close control of the welding
parameters is absolutely necessary in order to reach
satisfying results. Micronas, therefore, does not give
any implied or express warranty as to the ability to
weld the component.
1.7. Pin Connections and Short Descriptions
Pin
Pin Name Type Short Description
No.
1
V_DD
IN
Supply Voltage and
Programming Pin
2
GND
Ground
3
OUT
OUT Push-Pull Output
and Selection Pin
1 V_DD
OUT
3
2 GND
Fig. 1–1: Pin configuration
Micronas
Feb. 3, 2009; DSH000015_003EN
5