MT28S4M16LC Datasheet, PDF (35/48 Pages) Micron Technology – SYNCFLASH MEMORY

ABSOLUTE MAXIMUM RATINGS*
Voltage on RP# Relative to VSS .................... -1V to +10V
Voltage on VCC, VCCP or VCCQ Supply or Inputs,
Relative to VSS ....................................... -1V to +3.6V
Voltage on I/O Pins Relative to VSS .............. VCCQ ±0.3V
Operating Temperature,
T_A (ambient) ........................................ 0ºC to +70ºC
Storage Temperature (plastic) ........... -55ºC to +150ºC
Power Dissipation ........................................................ 1W
Short Circuit Output Current ................................ 50mA
4 MEG x 16
SYNCFLASH MEMORY
*Stresses greater than those listed under “Absolute
Maximum Ratings” may cause permanent damage to
the device. This is a stress rating only and functional
operation of the device at these or any other conditions
above those indicated in the operational sections of
this specification is not implied. Exposure to absolute
maximum rating conditions for extended periods may
affect reliability.
ELECTRICAL CHARACTERISTICS AND RECOMMENDED DC OPERATING CONDITIONS
(Notes: 1, 2); Commercial Temperature (0ºC ≤ T_A ≤ +70ºC)
PARAMETER/CONDITION
VCC SUPPLY VOLTAGE
VCCQ SUPPLY VOLTAGE
HARDWARE PROTECTION VOLTAGE
(RP# only)
INPUT HIGH VOLTAGE:
Logic 1; All Inputs
INPUT LOW VOLTAGE:
Logic 0; All Inputs
INPUT LEAKAGE CURRENT:
Any input 0V ≤ VIN ≤ VCC
(All other pins not under test = 0V)
OUPUT LEAKAGE CURRENT:
DQs are disabled; 0V ≤ VOUT ≤ VCCQ
OUTPUT LEVELS:
Output High Voltage
Output Low Voltage
(IOUT = -4mA)
(IOUT = -100mA)
(IOUT = -4mA)
(IOUT = 100mA)
SYMBOL
VCC
VCCQ
VHH
MIN
3.0
3.0
8.5
MAX
3.6
3.6
10
UNITS NOTES
V
V
V
VIH
2
VCCQ + 0.3 V
VIL
- 0.3
0.8
V
IL
-5
IOZ
-5
5
µA
5
µA
VOH
2.4
V
VOH
V
VOL
0.4
V
VOL
V
NOTE: 1. All voltages referenced to VSS.
2. An initial pause of 100µs is required after power-up. (VCC, VCCP and VCCQ must be powered up simultaneously. VSS and
VSSQ must be at same potential.)
4 Meg x 16 SyncFlash
MT28S4M16LC_6.p65 – Rev. 6, Pub. 9/01
35
Micron Technology, Inc., reserves the right to change products or specifications without notice.
©2001, Micron Technology, Inc.