93AA46AE48 Datasheet, PDF (6/26 Pages) Microchip Technology – 1K Microwire Serial EEPROM with EUI-48™ Node Identity

93AA46AE48
2.4 Erase
The ERASE instruction forces all data bits of the
specified address to the logical ‘1’ state. CS is brought
low following the loading of the last address bit. This
falling edge of the CS pin initiates the self-timed
programming cycle.
FIGURE 2-1:
CS
ERASE TIMING
CLK
The DO pin indicates the Ready/Busy status of the
device if CS is brought high after a minimum of 250 ns
low (TCSL). DO at logical ‘0’ indicates that programming
is still in progress. DO at logical ‘1’ indicates that the
register at the specified address has been erased and
the device is ready for another instruction.
Note:
After the Erase cycle is complete, issuing
a Start bit and then taking CS low will clear
the Ready/Busy status from DO.
TCSL
Check Status
DI
1
1
1 AN AN-1 AN-2 ••• A0
DO
High-Z
TSV
Busy
TWC
TCZ
Ready
High Z
DS20005229C-page 6
 2013-2016 Microchip Technology Inc.