MLX81100_14 Datasheet, PDF (16/19 Pages) Melexis Microelectronic Systems – DC-Motor Controller

MLX81100
DC-Motor Controller
5.2 TQFP 7x7 EP 48L
A A1 A2 b b1 D D1 D2 E E1 E2 e L N ccc ddd
min - 0.05 0.95 0.17 0.17
0.45
--
nom -
- 1.00 0.22 0.20 9.00 7.00 5.00 9.00 7.00 5.00 0.50 0.60 48 - -
max 1.20 0.15 1.05 0.27 0.23
0.75
0.08 0.08
Notes:
1. All Dimensioning and Tolerances conform to ASME Y14.5M-1994,
2. Datum Plane [-|-|-] located at Mould Parting Line and coincident with Lead, where Lead exists, plastic body at bottom of
parting line.
3. Datum [A-B] and [-D-] to be determined at centreline between leads where leads exist, plastic body at datum plane [-|-|-]
4. To be determined at seating plane [-C-]
5. Dimensions D1 and E1 do not include Mould protrusion. Dimensions D1 and E1 do not include mould protrusion. Allowable
mould protrusion is 0.254 mm on D1 and E1 dimensions.
6. 'N' is the total number of terminals
7. These dimensions to be determined at datum plane [-|-|-]
8. Package top dimensions are smaller than bottom dimensions and top of package will not overhang bottom of package.
9. Dimension b does not include dam bar protrusion, allowable dam bar protrusion shall be 0.08mm total in excess of the "b"
dimension at maximum material condition, dam bar can not be located on the lower radius of the foot.
10. Controlling dimension millimetre.
11. maximum allowable die thickness to be assembled in this package family is 0.38mm
12. This outline conforms to JEDEC publication 95 Registration MS-026, Variation ABA, ABC & ABD.
13. A1 is defined as the distance from the seating plane to the lowest point of the package body.
14. Dimension D2 and E2 represent the size of the exposed pad. The actual dimensions are specified ion the bonding diagram,
and are independent from die size.
1. 15. Exposed pad shall be coplanar with bottom of package within 0.05.
MLX81100 – Product Abstract
Page 16 of 19
June 2012
Rev 021