MAX1020_12 Datasheet, PDF (35/44 Pages) Maxim Integrated Products – 10-Bit, Multichannel ADCs/DACs with FIFO, Temperature Sensing, and GPIO Ports

10-Bit, Multichannel ADCs/DACs with FIFO,
Temperature Sensing, and GPIO Ports
CNVST
CS
(UP TO 514 INTERNALLY CLOCKED ACQUISITIONS AND CONVERSIONS)
SCLK
DOUT
EOC
MSB1
t_RDS
LSB1
MSB2
X = DON'T CARE.
Figure 6. Clock Mode 00—After writing a command byte, set CNVST low for at least 40ns to begin a conversion.
t_CSW
CNVST
(ACQUISITION 1)
(ACQUISITION 2)
CS
t_DOV
SCLK ^{(CONVERSION 1)}
(CONVERSION 2)
DOUT
MSB1
LSB1
MSB2
EOC
X = DON'T CARE.
Figure 7. Clock Mode 01—After writing a command byte, request multiple conversions by setting CNVST low for each conversion.
Do not issue a second CNVST signal before EOC goes
low; otherwise, the FIFO can be corrupted. Wait until all
conversions are complete before reading the FIFO. SPI
communications to the DAC and GPIO registers are per-
mitted during conversion. However, coupled noise may
result in degraded ADC signal-to-noise ratio (SNR).
Externally Timed Acquisitions and
Internally Timed Conversions with CNVST
ADC Conversions in Clock Mode 01
In clock mode 01, conversions are requested one at a
time using CNVST and performed automatically using
the internal oscillator. See Figure 7 for clock mode 01
timing after a command byte is issued.
Setting CNVST low begins an acquisition, wakes up the
ADC, and places it in track mode. Hold CNVST low for
at least 1.4µs to complete the acquisition. If reference
mode 00 or 10 is selected, an additional 45µs is
required for the internal reference to power up. If a tem-
perature measurement is being requested, reference
power-up and temperature measurement is internally
timed. In this case, hold CNVST low for at least 40µs.
Set CNVST high to begin a conversion. Sampling is
completed approximately 500ns after CNVST goes
high. After the conversion is complete, the ADC shuts
down and pulls EOC low. EOC stays low until CS or
CNVST is pulled low again. Wait until EOC goes low
before pulling CS or CNVST low. The number of CNVST
signals must equal the number of conversions request-
ed by the scan and averaging registers to correctly
update the FIFO. Wait until all conversions are com-
plete before reading the FIFO. SPI communications to
the DAC and GPIO registers are permitted during con-
______________________________________________________________________________________ 35