MAX12555 Datasheet, PDF (27/28 Pages) Maxim Integrated Products – 14-Bit, 95Msps, 3.3V ADC

14-Bit, 95Msps, 3.3V ADC
Aperture Jitter
Figure 4 depicts the aperture jitter (t_AJ), which is the
sample-to-sample variation in the aperture delay.
Output Noise (n_OUT)
The output noise (n_OUT) parameter is similar to the ther-
mal + quantization noise parameter and is an indication
of the ADC’s overall noise performance.
No fundamental input tone is used to test for n_OUT;
INP, INN, and COM are connected together and 1024k
data points collected. n_OUT is computed by taking the
RMS value of the collected data points after the mean
is removed.
Overdrive Recovery Time
Overdrive recovery time is the time required for the
ADC to recover from an input transient that exceeds the
full-scale limits. The MAX12555 specifies overdrive
recovery time using an input transient that exceeds the
full-scale limits by ±10%.
Pin Configuration
TOP VIEW
40 39 38 37 36 35 34 33 32 31
REFP 1
REFN 2
COM 3
GND 4
INP 5
INN 6
GND 7
DCE 8
CLKN 9
CLKP 10
MAX12555
EXPOSED PADDLE (GND)
30 D2
29 D3
28 D4
27 D5
26 D6
25 D7
24 D8
23 D9
22 D10
21 D11
11 12 13 14 15 16 17 18 19 20
THIN QFN
6mm x 6mm x 0.8mm
______________________________________________________________________________________ 27