MAX11200 Datasheet, PDF (22/27 Pages) Maxim Integrated Products – 24-Bit, Single-Channel, Ultra-Low-Power, Delta-Sigma ADCs with GPIO

24-Bit, Single-Channel, Ultra-Low-Power,
Delta-Sigma ADCs with GPIO
Table 16b. Output Data Formats for the Bipolar Input Range
INPUT VOLTAGE
VAINP - VAINN
≥ VREF
V_REF
×
_1−

1
2 ²³
−


1
DIGITAL OUTPUT CODE FOR BIPOLAR RANGES
OFFSET BINARY FORMAT
TWO’S COMPLEMENT FORMAT
0xFFFFFF
0x7FFFFF
0xFFFFFE
0x7FFFFE
V_REF
2²³ − 1
0
−V_REF
2²³ − 1
0x800001
0x800000
0x7FFFFF
0x000001
0x000000
0xFFFFFF
−V_REF
×
_1−

1
2 ²³
−


1
≤ -VREF
0x000001
0x000000
0x800001
0x800000
SOC: System Offset Calibration Register
The system offset calibration register is a 24-bit read/write register. The data written/read to/from this register is clocked
in/out MSB (most significant bit) first. This register holds the system offset calibration value. The format is always in
two’s complement binary format. A write to the system-calibration register is allowed. The value written remains valid
until it is either rewritten or until an on-demand system-calibration operation is performed, which overwrites the user-
supplied value.
The system offset calibration value is subtracted from each conversion result provided the NOSYSO bit in the CTRL3
register is set to 0. The system offset calibration value is subtracted from the conversion result after self-calibration
but before system gain correction. The system offset calibration value is also applied prior to the 1x or 2x scale factor
associated with bipolar and unipolar modes.
Table 17. SOC Register (Read/Write)
BIT
B23
B22
B21
B20
B19
B18
B17
B16
DEFAULT
0
0
0
0
0
0
0
0
BIT
B15
B14
B13
B12
B11
B10
B9
B8
DEFAULT
0
0
0
0
0
0
0
0
BIT
B7
B6
B5
B4
B3
B2
B1
B0
DEFAULT
0
0
0
0
0
0
0
0
22   �������������������������������������������������������������������������������������