MAX16047 Datasheet, PDF (21/62 Pages) Maxim Integrated Products – 12-Channel/8-Channel EEPROM-Programmable System Managers with Nonvolatile Fault Registers

12-Channel/8-Channel EEPROM-Programmable
System Managers with Nonvolatile Fault Registers
Voltage Tracking Sense (INS_) Inputs
GPIO1–GPIO4 are configurable as feedback sense
return inputs (INS_) for closed-loop tracking. Connect the
gate of an external n-channel MOSFET to each EN_OUT_
configured for closed-loop tracking. Connect INS_ inputs
to the source of the MOSFETs for tracking feedback.
Internal comparators monitor INS_ with respect to a
control tracking ramp voltage for power-up/power-
down and control each EN_OUT_ voltage. Under nor-
mal conditions each INS_ voltage tracks the ramp
voltage until the power-good voltage threshold has
been reached. The slew rate for the ramp voltage and
the INS_ to MON_ power-good threshold are program-
mable. See the Closed-Loop Tracking section.
INS_ connections also act as 100Ω pulldowns for
closed-loop tracking channels or for other power sup-
plies, if INS_ are connected to the outputs of the sup-
plies. Set the appropriate bits in r4Eh[7:4] to enable
pulldown functionality. See Table 12.
General-Purpose Logic Inputs/Outputs
Configure GPIO1–GPIO6 to be used as general-pur-
pose inputs/outputs. Write values to GPIOs through
r1Ah when operating as outputs, and read values from
r1Bh when operating as inputs. Register r1Bh is read-
only. See Table 6 for more information on reading and
writing to the GPIOs as logic inputs/outputs. Both regis-
ters r1Ah and r1Bh are located in the extended page
and are therefore not loaded from EEPROM on boot-up.
Table 6. GPIO Data-In/Data-Out Data
EXTENDED PAGE
ADDRESS
1Ah
1Bh
BIT RANGE
[0]
[1]
[2]
[3]
[4]
[5]
[7:6]
[0]
[1]
[2]
[3]
[4]
[5]
[7:6]
DESCRIPTION
GPIO Logic Output Data
0 = GPIO1 is a logic-low output
1 = GPIO1 is a logic-high output
0 = GPIO2 is a logic-low output
1 = GPIO2 is a logic-high output
0 = GPIO3 is a logic-low output
1 = GPIO3 is a logic-high output
0 = GPIO4 is a logic-low output
1 = GPIO4 is a logic-high output
0 = GPIO5 is a logic-low output
1 = GPIO5 is a logic-high output
0 = GPIO6 is a logic-low output
1 = GPIO6 is a logic-high output
Not used
GPIO Logic Input Data
GPIO1 logic-input state
GPIO2 logic-input state
GPIO3 logic-input state
GPIO4 logic-input state
GPIO5 logic-input state
GPIO6 logic-input state
Not used
______________________________________________________________________________________ 21