MAX16047 Datasheet, PDF (12/62 Pages) Maxim Integrated Products – 12-Channel/8-Channel EEPROM-Programmable System Managers with Nonvolatile Fault Registers

12-Channel/8-Channel EEPROM-Programmable
System Managers with Nonvolatile Fault Registers
Pin Description (continued)
PIN
MAX16047 MAX16049
37
37
38
38
39
39
41
41
42
42
43
43
44
44
45–50
45–50
51, 52
53–56
—
51, 52
—
—
NAME
FUNCTION
ABP
V_CC
DBP
GPIO1
GPIO2
GPIO3
GPIO4
EN_OUT1–
EN_OUT6
EN_OUT7–
EN_OUT8
EN_OUT9–
EN_OUT12
EP
Internal Analog Voltage Bypass. Bypass ABP to GND with a 1µF ceramic capacitor.
ABP powers the internal circuitry of the MAX16047/MAX16049. Do not use ABP to
power any external circuitry.
Power-Supply Input. Bypass V_CC to GND with a 10µF ceramic capacitor.
Internal Digital Voltage Bypass. Bypass DBP to GND with a 1µF ceramic capacitor. DBP
supplies power to the EEPROM memory, to the internal logic circuitry, and to the
internal charge pumps when the programmable outputs are configured as charge
pumps. All push-pull outputs are referenced to DBP. Do not use DBP to power any
external circuitry.
General-Purpose Input/Output 1. Configure GPIO1 as a logic input, a return sense line
for closed-loop tracking, an open-drain/push-pull fault output, or an open-drain/push-
pull output port. Use the EEPROM to configure GPIO1. See the General-Purpose
Inputs/Outputs section.
General-Purpose Input/Output 2. GPIO2 is configurable as a logic input, a return sense
line for closed-loop tracking, an open-drain/push-pull fault output, or an open-drain/
push-pull output port. Use the EEPROM to configure GPIO2. See the General-Purpose
Inputs/Outputs section.
General-Purpose Input/Output 3. GPIO3 is configurable as a logic input, a return sense
line for closed-loop tracking, an open-drain/push-pull fault output, or an open-drain/
push-pull output port. Use the EEPROM to configure GPIO3. See the General-Purpose
Inputs/Outputs section.
General-Purpose Input/Output 4. GPIO4 is configurable as a logic input, a return sense
line for closed-loop tracking, an open-drain/push-pull fault output, or an open-drain/
push-pull output port. GPIO4 is also configurable as an active-low manual reset, MR.
Use the EEPROM to configure GPIO4. See the General-Purpose Inputs/Outputs
section.
Output. EN_OUT1–EN_OUT6 are configurable with active-high/active-low logic and with
an open-drain or push-pull configuration. Program the EEPROM to configure
EN_OUT1–EN_OUT6 as a charge-pump output 5V greater than the monitored input
voltage (V_{MON_} + 5V). EN_OUT1–EN_OUT4 can also be used for closed-loop tracking.
Output. Configure EN_OUT_ with active-low/active-high logic and with an open-drain or
push-pull configuration.
Output. Configure EN_OUT_ with active-low/active-high logic and with an open-drain or
push-pull configuration.
Exposed Pad. Internally connected to GND. Connect to GND. EP also functions as a
heatsink to maximize thermal dissipation. Do not use as the main ground connection.
12 ______________________________________________________________________________________