805-501A-111 Datasheet, PDF (6/36 Pages) Magnetrol International, Inc. – KOTRON® MODEL 805 SMART RF LEVEL TRANSMITTER

1.3 QuickStart Wiring
WARNING! Explosion hazard. Do not connect or disconnect equip-
ment unless power has been switched off or the area is
known to be safe.
NOTE: Make sure the electrical wiring to the Kotron Model 805 trans-
mitter is complete and in compliance with all regulations
and codes.
1. Remove the cover of the wiring compartment of the
transmitter.
2. Attach a conduit fitting and mount the conduit plug in
Black (-)
Red (+)
the spare opening. Pull the power supply wire (twisted,
shielded pair of at least 22 AWG) through the conduit
(+)
fitting.
(-)
3. Connect shield to an earth ground at power supply and
leave floating at the transmitter.
4. Connect an earth ground to the nearest green ground
screw. (Not shown in illustration.)
5. Connect the positive supply wire to the (+) terminal and
the negative supply wire to the (-) terminal.
6. Replace the cover and tighten.
1.4 QuickStart Configuration and Calibration
(LCD version)
NOTE: The Kotron Model 805 transmitter can be equipped with either
a 2-line by 8-character LCD.
1. Power-up the transmitter.
The display changes every 5 seconds to show one of the
three measured values: Level, %Output, and Loop current.
2. Remove the cover of the electronic compartment.
3. Use the Up ( ) or Down ( ) Arrow keys to move from
one step of the configuration program to the next step.
Enter
Down
Up
4. Press the Enter Arrow ( ) key. The last character in the
first line of the display changes to an exclamation point
(!). For example: Units!
xxx
5. Use the Up ( ) or Down ( ) keys to increase or decrease
the value in the display or to scroll through the choices.
3
50-660 Kotron Model 805 Smart RF Level Transmitter