6437288-5 Datasheet, PDF (9/41 Pages) Tyco Electronics – SUPER SEAL CONNECTOR

Product Specification
108-78140
No.
7.9
7.10
7.11
7.12
7.13
7.14
ITEM
MEASUREMENT METHOD
PERFORMANCE
Contact
Solder bath：Sn-40Pb
Matte Tin plating only
Wet Solder Coverage：
Solderability Solder Temperature：235±5℃
Solder bath：Sn-3Ag-0.5Cu
(Plated area only)
Immersion Duration：5±0.5sec.
Solder Temperature：250±5℃
95% Min.
Flux：Alpha100
Immersion Duration：5±0.5sec.
AMP Spec. 109-5203
Flux：ULF-300R
Contact
Contact crimped on free-length of wire is inserted into the proper location of Contact can be inserted without bending of
Insertion
the plug housing. Holding position of the wire is 20mm apart from the crimp barrel. wire.
Characteristic Insertion speed is 100mm/min. or less.
(Between
Contact and
Housing)
Contact
Withdraw the contact inserted under the condition of 6.10.
There shall be no detrimental binding,
Withdrawal
crack and deformation.
Characteristic
(Between
Contact and
Housing)
Contact
About 100mm long wire is crimped with the plug housing connector and the receptacle 58.8N(6kgf) or more
Retention Force contact is fastened and then the load that causes separation of contact from the
(Between
housing with the wire pulled toward the axis at a constant speed of
Contact and approx.100mm/min. is measured.
Housing)
Strength of After the receptacle contact with wire crimped is fastened and then the load that Wire size
Crimp
causes wire breakage or separation of the wire from the crimped barrel with the 0.5
88.2N (9kgf) or more
Connection
wire pulled toward the axis at a constant speed of approx. 100mm/min. is measured. 0.85
127.4N(13kgf) or more
(Between
1.25
176.4N(18kgf) or more
Contact and
Wire)
Housing
After the cap housing is fastened, mated plug housing is pulled at a constant The lock mechanism shall not get released
Retention Force speed of approx. 100mm/min.
or broken less than 98N(10kgf).
(Housing
Locking
Strength)
Rev. A8
9 of 41