6437288-5 Datasheet, PDF (10/41 Pages) Tyco Electronics – SUPER SEAL CONNECTOR

Product Specification
108-78140
No.
7.15
ITEM
Seal Ability
MEASUREMENT METHOD
PERFORMANCE
Seal Ability is measured with compressed air fed into the Initial:
water-proof section of the connector. Before runnig the test, the
tip of the wire is soldered and then sealed with adhesives. (Fig.4) After Durability Test:
Measurement is taken with 9800Pa(gage)(0.1kg/c㎡)compressed air
fed into the connector submerged for duration of 30 seconds. If
the air does not leak for 30 seconds, the pressure is raised each
tine by an increment of 9800Pa(gage)(0.1kg/c㎡).
98kPa(gage)
2
(1kg/cm )or more
48kPa(gage)
2
(0.5kg/cm )or more
Lead
Fig.4
Adhesive
Soldering
Rev. A8
10 of 41