1410188-3 Datasheet, PDF (9/11 Pages) Tyco Electronics – MULTIGIG RT Signal Connectors, Tiers 1 and 2, RT2 Mezzanine,and RT2 Ruggedized

108-2072
4.
QUALITY ASSURANCE PROVISIONS
4.1. Qualification Testing
A. Specimen Selection
1. Tier 1 Product
Specimens shall be prepared in accordance with applicable Instruction Sheets and shall be
selected at random from current production. Each test group shall consist of 8 male and 8
female connector assemblies. Low level contact resistance circuit data, where tested, shall
be collected and evaluated from a minimum of 100 circuits chosen at random from those
assemblies. Low level contact resistance compliant pin data, where tested, shall be collected
and evaluated from a minimum of 50 pins chosen at random from those assemblies.
2. Tier 2 Product
Specimens shall be prepared in accordance with applicable Instruction Sheets and shall be
selected at random from current production. Test groups 1 and 2 shall each consist of 12
male and 12 female connector assemblies. Test groups 3 and 4 shall each consist of 8 male
and 8 female connector assemblies. Test group 5 shall consist of 7 male and 7 female
connector assemblies. Low level contact resistance circuit data, where tested, shall be
collected and evaluated from a minimum of 96 circuits chosen at random from those
assemblies. Low level contact resistance compliant pin data, where tested, shall be collected
and evaluated from a minimum of 100 pins chosen at random from those assemblies.
3. RT2 Mezzanine Product
Specimens shall be prepared in accordance with applicable Instruction Sheets and shall be
selected at random from current production. Each test group shall consist of 4, 42 mm stack
height Mezzanine connectors and 8, 20.3 mm MULTIGIG RT2 vertical receptacle assembly
backplane connectors. Low level contact resistance circuit data, where tested, shall be
collected and evaluated from a minimum of 100 circuits chosen at random from those
assemblies.
4. RT2 Ruggedized
Specimens shall be prepared in accordance with applicable Instruction Sheets and shall be
selected at random from current production. Each test group shall consist of 5 male and 5
female connector assemblies. Low level contact resistance circuit data, where tested, shall
be collected and evaluated from a minimum of 100 circuits chosen at random from those
assemblies.
B. Test Sequence
Qualification inspection shall be verified by testing specimens as specified in Figures 2A, 2B, 2C,
and 2D.
4.2. Requalification Testing
If changes significantly affecting form, fit or function are made to the product or manufacturing process,
product assurance shall coordinate requalification testing, consisting of all or part of the original testing
sequence as determined by development/product, quality and reliability engineering.
Rev E
9 of 11