1410188-3 Datasheet, PDF (10/11 Pages) Tyco Electronics – MULTIGIG RT Signal Connectors, Tiers 1 and 2, RT2 Mezzanine,and RT2 Ruggedized

108-2072
4.3. Acceptance
Acceptance is based on verification that the product meets the requirements of Figure 1. Failures
attributed to equipment, test setup or operator deficiencies shall not disqualify the product. If product
failure occurs, corrective action shall be taken and specimens resubmitted for qualification. Testing to
confirm corrective action is required before resubmittal.
4.4. Quality Conformance Inspection
The applicable quality inspection plan shall specify the sampling acceptable quality level to be used.
Power
A
Supply
Termination Resistance
Measurement Points
Dimensional and functional requirements shall be in accordance with the applicable product drawing
and this specification.
Figure 3
Low Level Contact Resistance Measurement Points (Circuit)
Rev E
10 of 11