1410188-3 Datasheet, PDF (2/11 Pages) Tyco Electronics – MULTIGIG RT Signal Connectors, Tiers 1 and 2, RT2 Mezzanine,and RT2 Ruggedized

108-2072
3.
REQUIREMENTS
3.1. Design and Construction
Product shall be of the design, construction and physical dimensions specified on the applicable
product drawing.
3.2. Materials
Materials used in the construction of this product shall be as specified on the applicable product
drawing.
3.3. Ratings
● Operating Voltage: 50 volts AC peak or DC
● Current: 1 ampere at <30°C (single circuit, free air)
● Temperature: -55 to 105°C
3.4. Performance and Test Description
Product is designed to meet the electrical, mechanical and environmental performance requirements
specified in Figure 1. Unless otherwise specified, all tests shall be performed at ambient environmental
conditions.
3.5. Test Requirements and Procedures Summary
Test Description
Initial examination of product.
Requirement
Meets requirements of product
drawing.
Final examination of product.
Meets visual requirements.
ELECTRICAL
Low level contact resistance, circuit. 80 milliohms maximum initial.
5 milliohms maximum average
increase.
10 milliohms maximum individual
increase.
Low level contact resistance,
compliant pin.
1 milliohm maximum initial.
1 milliohm maximum change.
Insulation resistance.
1000 megohms minimum.
Figure 1 (continued)
Procedure
EIA-364-18.
Visual and dimensional (C of C)
inspection per product drawing.
EIA-364-18.
Visual inspection.
EIA-364-23.
Subject specimens to 100
milliamperes maximum and 20
millivolts maximum open circuit
voltage.
See Figure 3.
EIA-364-23.
Subject specimens to 100
milliamperes maximum and 20
millivolts maximum open circuit
voltage.
See Figure 4.
EIA-364-21.
Test between any adjacent pair of
signal contacts, or from any signal
contact to an adjacent ground pin
of mated specimens at 100 volts
DC.
Rev E
2 of 11