1410188-3 Datasheet, PDF (3/11 Pages) Tyco Electronics – MULTIGIG RT Signal Connectors, Tiers 1 and 2, RT2 Mezzanine,and RT2 Ruggedized

Test Description
Withstanding voltage.
Temperature rise vs current.
Vibration, sinusoidal.
Mechanical shock.
Durability.
Mating force.
Unmating force.
Compliant pin insertion.
Compliant pin retention.
Rev E
108-2072
Requirement
Procedure
1 minute hold with no breakdown or EIA-364-20, Condition I.
flashover.
500 volts AC peak or DC at sea
level.
Test between any adjacent pair of
signal contacts, or from any signal
contact to an adjacent ground pin of
mated specimens.
30°C maximum temperature rise at
1 ampere load, single circuit in free
air using thermography.
EIA-364-70, Method 1.
Stabilize at a single current level
until 3 readings at 5 minute intervals
are within 1°C.
MECHANICAL
No discontinuities of 1 microsecond EIA-364-28, Test Condition II.
or longer duration.
Subject mated specimens to 10-
See Note.
500-10 Hz traversed in 15 minutes
with 1.5 mm [.06 in] maximum total
excursion. Two hours in each of 3
mutually perpendicular planes.
No discontinuities of 1 microsecond EIA-364-27, Method H.
or longer duration.
Subject mated specimens to 30 G's
See Note.
half-sine shock pulses of 11
milliseconds duration. Three shocks
in each direction applied along 3
mutually perpendicular planes, 18
total shocks.
See Note.
EIA-364-9.
Mate and unmate specimens for
200 cycles at a maximum rate of
500 cycles per hour.
0.75 N [2.7 ozf] maximum per
contact. Average for entire
connector.
EIA-364-13.
Measure force necessary to mate
specimens at a maximum rate of
12.7 mm [.5 in] per minute.
0.15 N [.54 ozf] minimum per
contact. Average for entire
connector.
EIA-364-13.
Measure force necessary to unmate
specimens at a maximum rate of
12.7 mm [.5 in] per minute.
31 N [7 lbf] maximum per pin
average.
AMP Spec 109-41.
Measure force necessary to
correctly apply a connector
assembly to a printed circuit board
at a maximum rate of 12.7 mm [.5
in] per minute.
13.35 N [3 lbf] minimum.
AMP Spec 109-30.
Measure force necessary to unseat
a single pin in a correctly applied
connector assembly from its printed
circuit board hole at a maximum
rate of 12.7 mm [.5 in] per minute.
Figure 1 (continued)
3 of 11