1-380999-0 Datasheet, PDF (74/98 Pages) Tyco Electronics – 5.0 mm Power Key Connectors (5.0 PKC) (Wire-to-Board)

Automatic Machines
AMPOMATOR System III
Leadmaker
Soft Shell
Pin and Socket Connectors
Application Tooling (Continued)
System III Applicator
AMP
The AMPOMATOR System III
Leadmaker is designed for
the demands of low-volume/
high-mix manufacturing and
precision quality. This lead-
maker combines the best wire
processing capabilities with
new technologies in terminal
feeding and machine set-up
found in the System III
Applicator to offer significant
advantages for higher through-
put and efficiencies.
Request Catalog 1654956-5.
The System III Applicator
introduces several new
technologies into the applicator
including a precision servo-
electric motorized feeding
system, a built-in data module
for storing terminal crimp and
set-up information, a precision
fit round ram, and a newly
designed terminal depressor.
It still utilizes the proven quality
of the HD-M crimper and
anvil tooling.
AMPOMATOR CLS IV+
Lead-Making Machines,
356500-1, -2
Fully-automatic machines
that measure, cut, strip
and terminate single leads.
Microprocessor-controlled, and
programmed and operated
using an easy-to-follow, menu-
driven touchscreen. Features
include direct-drive terminating
units with precision crimp height
adjustment, fully programmable
setups, wire runout and splice
detection, and motorized
pre-feed with wire straightener.
Crimp quality monitoring is
also available.
Specifications
Width—159 [4 039]
Depth—68 [1 730]
Height—90 [2 285] min., with
24 [610] dia. reel
Weight—2 000 lb [907 kg]
Electrical—220 VAC, 50 or 60 Hz,
1 ∅, 20 A with neutral and ground
Air—90 psi [6.21 bar], 15 scfm
[0.00708 m³/s] sustained
Wire Range—26-10 AWG
[0.12-6 mm²] stranded, 26-16 AWG
[0.12-1.4 mm²] solid
Lead Lengths—3-90 [76.2-2 286],
90-1 000 [2 286-25 400] with long lead
conveyors
For more information, request Catalog
124324.
EDGE Electronic Applicator
Counter
The new, versatile EDGE appli-
cator counter tracks wearable
tool usage for the most effec-
tive maintenance planning. The
completely electronic counter,
with clear LCD display, indi-
cates cycles since installation.
By performing maintenance at
measured intervals with pre-set
limits, operators avoid break-
downs and rejects caused by
tool wear or mis-adjustment.
For more information, request Catalog
1773385.
208
Catalog 82181
Revised 4-08
www.tycoelectronics.com
Dimensions are in inches and
millimeters unless otherwise
specified. Values in brackets
are metric equivalents.
Dimensions are shown for
reference purposes only.
Specifications subject
to change.
USA: 1-800-522-6752
Canada: 1-905-470-4425
Mexico: 01-800-733-8926
C. America: 52-55-1106-0803
South America: 55-11-2103-6000
Hong Kong: 852-2735-1628
Japan: 81-44-844-8013
UK: 44-8706-080-208