409-2426 Datasheet, PDF (7/17 Pages) Tyco Electronics – Pneumatic Tools

Pneumatic Tools 68068 and 68068-1
409-2426
TERMINAL OR SPLICE
COMPALUM* Insulation Piercing
Terminal and Splice
COMPALUM Bar Crimp Terminal and Splice
SOLISTRAND* Terminal and Splice
PLASTI-GRIP* Terminal
Pre-Insulated Vinyl (ECV) Closed End Splice
WIRE RANGE
SIZE
(AWG)
CMA
12-10
5,180-13,100
8
13,100-20,800
8
13,100-20,800
6
20,800-33,100
6
20,800-33,100
8
13,100-20,800
6
20,800-33,100
6
20,800-33,100
4
33,100-52,600
12-6
19,500-42,700
Figure 5
JAW ASSEMBLY
PART
NUMBER
INSTRUCTION
SHEET
68101-0
68192-1
68102-0
68106-0
68135-0
68136-0
68233-1
68254-1
68268-1
408-23930
408-2394
408-2395
408-2532
408-2564
3. Inspect the jaw closure surfaces, jaw bottoming surfaces, and jaw cam rollers for deposits of dirt or
other foreign particles. If necessary, wipe clean with a clean cloth. Re–lubricate the jaw cam rollers
according to Paragraph 5.3. Make sure the jaw cam rollers are not binding.
4. Pull one cowling pin and remove the retaining pin from the lower housing cover. The cover will swing
open. See Figure 6.
5. Remove the pivot pins.
6. Orient the jaws as described in the instruction sheet packaged with the jaw assembly (refer to Figure
5). Position the jaws in the tool housing ensuring that the jaw cam rollers are properly mated with the
tool cam and the pivot pin holes of the jaws and the tool housing are aligned. See Figure 6.
7. Insert the pivot pins.
CAUTION
To avoid damage to the tool or pivot pins, make sure that the pivot pins are fully inserted.
!
8. Pivot the lower housing cover into the closed position, and re–install the retaining pin and cowling pin.
3.2. Removing Jaw Assembly
1. DISCONNECT the tool from the air supply.
DANGER
To prevent personal injury, ALWAYS DISCONNECT the tool from the air supply when removing the jaw assembly.
2. Pull one cowling pin and remove the retaining pin from the lower housing cover. The cover will swing
open.
3. Remove the pivot pins, then remove the jaws.
Rev A
Tyco Electronics Corporation
7 of 17