408-4050 Datasheet, PDF (6/6 Pages) Tyco Electronics – Crimp Quality Monitor

9. Connect the cable to the sensor. Observe the
connector orientation marks.
10. Reconnect the power to the machine and turn
the machine on.
11. Adjust the sensor according to Section 5,
ADJUSTMENT.
12. Attach cover to gib.
13. Enter the position sensor numbers.
408-4050
8. PARTS REPLACEMENT
Refer to the assembly drawings shipped with the CQM
Adapter for replacement part numbers. No spare parts
are recommended for this assembly. Order parts
through your Tyco Electronics representative, or call 1-
800-526-5142, or send a facsimile of your purchase
order to 1-717-986-7605, or write to:
CUSTOMER SERVICE (038-035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105-3608
9. REVISION SUMMARY
Since the previous revision of this instruction sheet,
the TE logo has been applied.
Rev E
6 of 6