408-4050 Datasheet, PDF (1/6 Pages) Tyco Electronics – Crimp Quality Monitor

Crimp Quality
Monitor (Ref)
Crimp Quality Monitor (CQM)
Adapters 122990-[ ] and 1424265-1
Instruction Sheet
408-4050
03 MAR 11 Rev E
AMP-O-LECTRIC* Model
“G” Terminating Machine (Ref)
NOTE: Refer to Drawing 1320431 for
CQM Adapter Hookup to the AMP 3K/
AMP 5K Terminating Machines
Ram Assembly
CQM Adapter
Figure 1
1. INTRODUCTION
These instructions cover Crimp Quality Monitor (CQM)
Adapter 122990-[ ], which is used with
AMP-O-LECTRIC Model "G" Terminating Machines
354500-[ ] and 1213127-[ ], and CQM Adapter
1424265-1, which is used with the AMP 3K
Terminating Machines 1725950-[ ] and AMP 5K
Terminating Machines 1725900-[ ].These adapters are
used in conjunction with Crimp Quality Monitor
2031940-1.
NOTE
i
All dimensions are in millimeters [with inches in
brackets]. Illustrations are for identification only and
are not drawn to scale.
For additional information regarding operation, setup,
and adjustment of the AMP 3K/5K Terminating
Machines, refer to Customer Manual 409-10047. For
additional information on the Crimp Quality Monitor,
refer to Customer Manual 409-10091.
Reasons for reissue are provided in Section 9,
REVISION SUMMARY.
2. DESCRIPTION
The CQM Adapter consists of two sensor assemblies,
mounting hardware, and a cable. These items allow
the Crimp Quality Monitor to monitor the crimping
process without the use of special applicators.
©2011 Tyco Electronics Corporation, Berwyn, PA
TOOLING ASSISTANCE CENTER 1-800-722-1111
All Rights Reserved
PRODUCT INFORMATION 1-800-522-6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names might be trademarks of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 6
LOC B