408-10207 Datasheet, PDF (5/5 Pages) Tyco Electronics – PRO–CRIMPER III Hand Tool Assembly

PRO-CRIMPER III Hand Tool Assembly 1976444-1 with Die Assembly 1976444-2
408-10207
3. Observe the ratchet adjustment wheel. If a
tighter (smaller) crimp height is required, rotate the
adjustment wheel counterclockwise to a
higher–numbered setting. If a looser (larger) crimp
height is required, rotate the adjustment wheel
clockwise to a lower–numbered setting.
4. Re–assemble the lockscrew.
7.2. Visual Inspection
Inspection of the dies should be made on a regular
basis to ensure that they have not become worn or
damaged. Inspect the crimping chambers for
flattened, chipped, worn, or broken areas. If damage
or abnormal wear is evident, the dies must be
replaced. Refer to Section 7, REPLACEMENT.
5. Make a sample crimp. If the crimp height is
acceptable, the adjustment setting is correct. If the
crimp height is unacceptable, continue to adjust
the ratchet, and again measure a sample crimp.
7. MAINTENANCE AND INSPECTION
7.1. Maintenance
Ensure that the tool frame and dies are clean by
wiping them with a clean, soft cloth. Remove any
debris with a clean, soft brush. Do not use objects
that could damage any components. When not in use,
keep tool handles closed to prevent objects from
becoming lodged in the dies, and store in a clean, dry
area.
8. REPLACEMENT
Customer–replaceable parts are shown in Figure 1.
Available separately, Repair Kit 679221–1 includes a
replacement lock nut and a variety of pins, rings,
screws, and springs. If the dies are damaged or worn
excessively, they must be replaced. Order the repair
kit and replaceable parts through your representative,
or call 1–800–526–5142, or send a facsimile of your
purchase order to 717–986–7605, or write to:
CUSTOMER SERVICE (038–035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105–3608
9. REVISION SUMMARY
S Initial release of instruction sheet
Rev A
Tyco Electronics Corporation
5 of 5