408-10207 Datasheet, PDF (1/5 Pages) Tyco Electronics – PRO–CRIMPER III Hand Tool Assembly

PRO-CRIMPER* III
Hand Tool Assembly 1976444-1
With Die Assembly 1976444-2
Instruction Sheet
408-10207
31 MAR 08 Rev A
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low volume
applications. A wide selection of powered application equipment for extended-use, production operations is available.
Locator
Assembly
Stationary
Jaw
Back of Tool
(Wire Side)
Die Assembly
Pivot Pin
Moving
Jaw
PRO-CRIMPER III Hand Tool
Frame 354940-1
(See Instruction Sheet 408-9930)
Ratchet Adjustment
Wheel
The PRO-CRIMPER III Hand Tool is a Commercial" grade tool and is
designed primarily for field installation, repair, maintenance work, or
prototyping in industrial, commercial, or institutional applications. Product
crimped with this tool will meet the crimp height requirement for hand tools in
the appropriate Application Specification (114-series), but may not comply
with other feature parameters of the specification. A variety of tools are offered
to satisfy your performance requirements. For additional information, contact
the Tooling Assistance Center at 1-800-722-1111.
Stationary Handle
Moving Handle
DIE
ASSEMBLY
{ ^LOCATOR
ASSEMBLY
SOCKET
} ^CONTACT
SUPPORT
h ^PRODUCT
FAMILY
1976444-2
58516-1
679277-1
VAL-U-LOK*
Contacts
{ Supplied with Die Assembly, Also Available Separately
} Available Separately (Pin Contact Support Supplied with Locator Assembly)
Figure 1
WIRE
SIZE (AWG)
INSULATION
DIAMETER RANGE
STRIP LENGTH
RANGE
1.80-3.10 mm
3.0-3.5 mm
16
[.071-.122 in.]
[.118-.138 in.]
h For specific contact part number, contact the Tooling Assistance
Center at the number at the bottom of this page.
1. INTRODUCTION
PRO–CRIMPER III Hand Tool Assembly 1976444–1
consists of PRO–CRIMPER III Hand Tool Frame
354940–1 and Die Assembly 1976444–2. The tool
assembly is used to crimp the contacts listed in
Figure 1.
For additional information on the hand tool frame,
refer to 408–9930. Read these instructions thoroughly
before using the tool assembly.
NOTE
i
Dimensions in this instruction sheet are in
millimeters [with inches in brackets]. Figures are
not drawn to scale.
2. DESCRIPTION (Figure 1)
The tool frame features a stationary jaw and handle, a
moving jaw and handle, and an adjustable ratchet that
ensures full crimping. The tool frame holds the die
assembly.
E2008 Tyco Electronics Corporation, Harrisburg, PA
TOOLING ASSISTANCE CENTER 1-800-722-1111
All International Rights Reserved
PRODUCT INFORMATION 1-800-522-6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 5
LOC B