408-10413 Datasheet, PDF (4/6 Pages) Tyco Electronics – Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools.

408-10413
Figure 6
4. Place the notched ribbon cable in the
connector with the notch being aligned with the
connector post. See Figure 5B.
NOTE
i
The TE logo should be facing the moving jaw of the
hand tool.
5. Place the base half of the connector in the die
nest. See Figure 5C.
6. Hold the ribbon cable steady while squeezing
the hand tool handles.
7. Release the handles to open the hand tool.
8. Remove the crimped connector from the die
set.
5.3. Crimping the Straight Connector (Figure 6)
3. Place the prepared ribbon cable fully into the
connector.
4. Squeeze the hand tool handles while keeping
the ribbon cable fully inserted into the connector.
5. Release the handles to open the hand tool.
6. Remove the crimped connector from the die
set.
1. Install the multi-nest die set (blue dot) into the
hand tool as specified in Section 3.
2. Place the connector in the die set nest as
shown in Figure 6.
5.4. Crimping the Terminator (Figure 7)
1. Install the multi-nest die set (blue dot) into the
hand tool as specified in Section 3.
Rev A
Figure 7
4 of 6